PELCO EXSITE IPSXM
LANGUAGE | ENGLISH | |||
UNIT INVERSION | OFF | |||
<SYSTEM INFORMATION> |
| |||
<DISPLAY SETUP> |
| |||
<UNIT SETTINGS> |
| |||
<POSITION CALIBRATION> |
| |||
RESET CAMERA |
| |||
CYCLE CAMERA POWER |
| |||
REBOOT SYSTEM |
| |||
EXIT |
| |||
|
|
|
| |
|
|
|
|
|
UNIT SETTINGS |
| |||
<CAMERA> |
| |||
<MOTION> |
| |||
<POWER UP> |
| |||
<LINE SYNC> |
| |||
<PRESETS> |
| |||
<PATTERNS> |
| |||
<ZONES> |
| |||
<WINDOW BLANKING> |
| |||
<ALARMS> |
| |||
<WIPER> |
| |||
<AUX> |
| |||
<CLEAR> |
| |||
<PASSWORD> |
| |||
BACK |
| |||
EXIT |
| |||
|
| |||
|
|
|
|
|
AUX |
| |||
|
| |||
AUX 1 MODE | TOGGLE | |||
DWELL TIME (SECS) | 1 | |||
AUX 2 MODE | TOGGLE | |||
DWELL TIME (SECS) | 1 | |||
BACK |
| |||
EXIT |
| |||
AUX
An auxiliary output is a programmable signal from the system that can trigger another device to operate. An auxiliary output is programmable to trigger from an alarm or from a controller.
An AUX 1 command from the controller will activate the relay in the system and operate the device that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system switch to activate automatic monitor switching and recording.
An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the device that is connected to it.
The following are the available AUX MODE settings:
TOGGLE (default) | Changes the state of the auxiliary output every time an AUX command is |
| received from the controller. |
LATCHING | Must receive an AUX ON/AUX OFF command from the controller to turn the |
| auxiliary output on/off. |
MOMENTARY | An AUX ON command from the controller turns the auxiliary output on for the |
| programmed DWELL TIME. The auxiliary output will automatically turn off |
| when the dwell time is finished. |
40 |
|