Pelco C1300M-C (11/08) manual Password

Page 42

PASSWORD

PELCO EXSITE IPSXM

LANGUAGE				ENGLISH
UNIT INVERSION				OFF
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<UNIT SETTINGS>
<POSITION CALIBRATION>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT


UNIT SETTINGS

<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<WIPER>
<AUX>
<CLEAR>
<PASSWORD>
BACK
EXIT


PASSWORD


ENABLE PASSWORD				OFF
<EDIT PASSWORD>
BACK

EDIT THE PASSWORD
- - - - - - - - - - - -
1234567890	OK
ABCDEFGHIJ	CANCEL
KLMNOPQRST
UVWXYZ.,-/	SPACE
abcdefghij	BACKSPACE
klmnopqrst
uvwxyz#&:”

ExSite IPSXM features password protection to prevent unauthorized changes to the system settings. An operator can open the System Information and Display Setup Screens, but cannot access any of the Unit Settings menus.

Controller/keyboard commands cannot override password-protected settings. If a keyboard is used to set a preset, pattern, or zone, the Enter Password screen appears on the monitor. The password must be entered before programming can continue.

At least one character must be entered to create a valid password.

42	C1300M-C (11/08)

Image 42

Contents ExSite Series Explosionproof Positioning System Page Contents Specifications Regulatory Notices Radio and Television InterferenceModels Configure DoneWelcome Getting StartedHow to Operate Your System Accessing Main Menu Preset KBD200A/KBD300A Direct Mode onlyKBD4000/KBD4002 Genex Multiplexer Quick Start Guide System Setup C1300M-C 11/08 Language OFF default Use for normal installations refer to Figure Unit InversionSystem Information Display Setup Label Positions Unit Settings CameraIR CUT Filter 23X DAY/NIGHT Camera DarkAdvanced Camera Settings Shutter SpeedAGC Limit Auto White Balance Auto IrisAuto Sharpness GainWide Dynamic Range 23X DAY/NIGHT Camera Backlight Compensation BLCVideo Level NormalProportional PAN There are two proportional pan modes On defaultMotion Amount of zoomPark Time Scan Speed Preset Freeze FrameThere are three preset freeze frame settings Image is never frozenScan Limit StopsManual Limit stop is reachedAzimuth Zero Power UP Power UP ActionNone Phase settings range from 0-359 degrees Line SyncSystem synchronizes to an internal clock Presets Enable Motion Detection 23X DAY/NIGHT Camera Edit Detection Areas 23X DAY/NIGHT CameraActivate AUX Command 23X DAY/NIGHT Camera Triggers a command to AUXAUX Time 23X DAY/NIGHT Camera Patterns Zones Window Blanking To set a window blanking areaClear Window Available OFF default No blankingReverse Blank ALL ABOVE/BLANK ALL belowResume AlarmsReset Delay SequenceMEDIUM/LOW Normally open Wiper Control Wiper ModeWiper Wiper DwellSET Washer Sequence Received from the controller When the dwell time is finishedAUX LatchingClear Password Position Calibration Cycle Camera Power Reset, Cycle Power, RebootReset Camera Reboot SystemSoftware/Language File Upload Upload IconNtsc SpecificationsNTSC, PAL PALProduct Warranty and Return Information