All LEDs Lit: shaver is fully recharged
LEDs Light Sequentially: shaver is operating normally
When using the shaver for the first time or if the shaver has not been used for a long time, charge the shaver for 16 hours.
1.Insure that the On/Off switch is in the “Off” position. First, connect the power cord to the shaver and then plug it into an electric outlet.
2.During recharging, the LEDs will flash and
then remain lit as the unit recharges. Recharging generally takes one hour. When fully charged, the shaver will provide approximately one week of shaving run time.
Storing the Shaver and Power cord
If the shaver is to remain unused for a long period of time, store the unit and power cord in a cool, dry place. Do not wrap the cord around
the unit during storage. Avoid twisting the power cord. Be sure to unplug and untwist the cord if it becomes twisted during use or while charging.
Removing the Batteries for Disposal/ Recycling It is important that the rechargeable batteries in the shaver be recycled or properly disposed of after it has reached the end of its useful life.
Turn the On/Off Switch “on” and run the shaver until the inner cutters stop.
1.Remove the headguard, foil screen assembly, and inner cutters.
2.Remove the 2 screws on the top of shaver. (Fig.
1) | 1 |
|
3. Remove the 5 screw covers on the back of shaver. Remove 2 side panels.
AXIS NITRIS AND AXIS FUEL 20 ENGLISH | AXIS NITRIS AND AXIS FUEL 21 ENGLISH |