Switching on
•To start the energy supply, slide switch (B) up to position «1».
•Then slide it further up to the «start» position until you can clearly hear a click. Let the switch move back to position «1» = on.
•The ignition window (C) lights up to show that the appliance starts heating up. In the unlikely case that it does not heat up, make sure the energy supply is on and push the switch (B) to the start position again.
•After approximately 2 minutes, the ready indicator dot (D) changes colour. The appliance is now ready for use.
It is
Subject to change without notice.
This product conforms to the
Straightening
•Make sure your hair is completely dry before using the appliance.
•First, comb or brush your hair to remove tangles.
•Section your hair off. Place a strand (3 - 4 cm width maximum) between the straightening plates and clamp it close to the roots. It is easier if you hold the hair section at an angle away from your head.
•For straightening, slowly pull the appliance towards the hair ends with a continuous movement. Do not rest on one spot for longer than 2 sec- onds.
After use
To switch off, slide the energy supply switch (B) back to position «0» = off.
Cleaning and storage
Make sure the appliance is switched off and cold. You may clean the appliance with a soft damp cloth. Never immerse the appliance in water.
After use or cleaning, always place the protective cover (A) on the appliance.
When travelling by air, please note that no more than one appliance may be carried by each crew member or passenger aboard an aircraft in checked luggage, if the protective cover is secured over the heating element. Separate gas refills are not permitted.
9