Lifescan Blood Glucose Monitor System manual Enter the Code Mode, Match the Code Numbers

Page 17

STEP 1

Enter the Code Mode.

Start with the meter turned off. Insert a PocketScan™ Test Strip to turn on the meter. All segments of the display will appear followed by the date and time. Next, the code number will appear on the display for three seconds.

STEP 2

Match the Code Numbers.

Compare the code number on the meter display with the code number on the test strip vial. If the two code numbers match, you may begin testing. If they do not match, follow Step 3. When you first use the meter, three dashes (---) will appear, showing that there is no code stored in the memory.

(Example)

(Example)

7

Image 17

Contents Owner’s Booklet Page Owner’s Booklet 5.8 Dear PocketScan System Owner Page Important Information Table of Contents Using the Meter Memory Viii Getting Started PocketScan Blood Glucose Meter Test Port Target Area PocketScan Test StripsImportant Test Strip Information Coding the Meter Checking the DisplayMatch the Code Numbers Enter the Code ModeCode the Meter Checking the System with PocketScan Control Solution Do a control solution test Important Control Solution Test Information Insert Test Strip Result Appears in 15 Seconds Apply Control SolutionAt UK 0800 Republic of Ireland 1800 Comparing control solution resultsTesting Your Blood Cock the Penlet II Sampler Getting a Drop of BloodInsert a Lancet in the Penlet II Automatic Blood Sampler Remove the Lancet Wash Your HandsLance Your Finger Step-by-Step Test Procedure Accurate Results in Just 15 Seconds Apply SampleExample Special MessagesUsing the Meter Memory Recall Test Results Data Downloading Exit the Memory ModeResults References Batteries MaintenanceSymbol appears on the display Display Messages and PROBLEM- Solving Guide Message What IT Means Result. At the end of the count Message What IT Means Message What IT Means Action That Blood Sample was Tests were performed within This period Select the appropriate unit of measurement Probable Cause What to do Calibration Plasma/Serum Test Time 15 secondsAutomatic Shutoff Two minutes after last user action Operating RangesSet the Day Changing the DateSet the Year Set the Month Set the Minutes Changing the TimeSet the Hour Select mmol/L or mg/dL Exit the Setting ModePage Test Page 1998 Visit the LifeScan website at