Lifescan Blood Glucose Monitor System manual Wash Your Hands, Lance Your Finger, Remove the Lancet

Page 27

it does not click, the PENLET II Sampler may have been cocked when the lancet was inserted.

STEP 3

Wash Your Hands.

Use warm, soapy water. Rinse and dry them thoroughly. Hanging your arm down for 20 seconds will help if you have diffi- culty obtaining enough blood.

STEP 4

Lance Your Finger.

Hold the PENLET II Sampler firmly against the side of your finger. Press the release button. If necessary, squeeze your finger gently to obtain a drop of blood.

STEP 5

Remove the Lancet.

Remove the cap. Grasp the two prongs near the release button and pull back on the sliding barrel. The used lancet will drop out. Discard it in a container for sharp objects.

17

Image 27

Contents Owner’s Booklet Page Owner’s Booklet 5.8 Dear PocketScan System Owner Page Important Information Table of Contents Using the Meter Memory Viii Getting Started PocketScan Blood Glucose Meter Test Port Target Area PocketScan Test StripsImportant Test Strip Information Coding the Meter Checking the DisplayMatch the Code Numbers Enter the Code ModeCode the Meter Checking the System with PocketScan Control Solution Do a control solution test Important Control Solution Test Information Insert Test Strip Result Appears in 15 Seconds Apply Control SolutionAt UK 0800 Republic of Ireland 1800 Comparing control solution resultsTesting Your Blood Getting a Drop of Blood Insert a Lancet in the Penlet II Automatic Blood SamplerCock the Penlet II Sampler Wash Your Hands Lance Your FingerRemove the Lancet Step-by-Step Test Procedure Accurate Results in Just 15 Seconds Apply SampleExample Special MessagesUsing the Meter Memory Recall Test Results Data Downloading Exit the Memory ModeResults References Batteries MaintenanceSymbol appears on the display Display Messages and PROBLEM- Solving Guide Message What IT Means Result. At the end of the count Message What IT Means Message What IT Means Action That Blood Sample was Tests were performed within This period Select the appropriate unit of measurement Probable Cause What to do Operating Ranges Test Time 15 secondsCalibration Plasma/Serum Automatic Shutoff Two minutes after last user actionChanging the Date Set the YearSet the Day Set the Month Changing the Time Set the HourSet the Minutes Select mmol/L or mg/dL Exit the Setting ModePage Test Page 1998 Visit the LifeScan website at