Lifescan Blood Glucose Monitor System manual Checking the System with PocketScan Control Solution

Page 19

Checking the System with PocketScan™ Control Solution

PocketScan Control Solution is used to check that the meter and test strips are working together as a system and that you are performing the test correctly. It is very important that you do this simple check routinely to make sure you get accurate results.

PocketScan Control Solution contains a known amount of glucose that reacts with PocketScan™ Test Strips. Compare your control solution test results with the expect- ed range printed on the test strip vial label. Control solution should be used to:

•Practice the test procedure.

•Make sure your meter and test strips are working together properly.

•Ensure you are performing the test cor- rectly.

For in vitro diagno

Not intended for h consumption.

Solution	Unop

Control	Lot N
	AW 050

9

Image 19

Contents Owner’s Booklet Page Owner’s Booklet 5.8 Dear PocketScan System Owner Page Important Information Table of Contents Using the Meter Memory Viii Getting Started PocketScan Blood Glucose Meter Test Port Target Area PocketScan Test StripsImportant Test Strip Information Coding the Meter Checking the DisplayMatch the Code Numbers Enter the Code ModeCode the Meter Checking the System with PocketScan Control Solution Do a control solution test Important Control Solution Test Information Insert Test Strip Result Appears in 15 Seconds Apply Control SolutionAt UK 0800 Republic of Ireland 1800 Comparing control solution resultsTesting Your Blood Insert a Lancet in the Penlet II Automatic Blood Sampler Getting a Drop of BloodCock the Penlet II Sampler Lance Your Finger Wash Your HandsRemove the Lancet Step-by-Step Test Procedure Accurate Results in Just 15 Seconds Apply SampleExample Special MessagesUsing the Meter Memory Recall Test Results Data Downloading Exit the Memory ModeResults References Batteries MaintenanceSymbol appears on the display Display Messages and PROBLEM- Solving Guide Message What IT Means Result. At the end of the count Message What IT Means Message What IT Means Action That Blood Sample was Tests were performed within This period Select the appropriate unit of measurement Probable Cause What to do Operating Ranges Test Time 15 secondsCalibration Plasma/Serum Automatic Shutoff Two minutes after last user actionSet the Year Changing the DateSet the Day Set the Month Set the Hour Changing the TimeSet the Minutes Select mmol/L or mg/dL Exit the Setting ModePage Test Page 1998 Visit the LifeScan website at