Lifescan Blood Glucose Monitor System manual Apply Sample, Accurate Results in Just 15 Seconds

Page 29

STEP 2

Apply Sample.
Obtain a drop of blood from your finger
using the PENLET II Automatic Blood
Sampler. When the	symbol appears on
the display, touch a small drop of blood to
the white target area of the test strip. Hold
your finger against the test strip until the

meter begins to count down. (If you do not apply a blood sample within two min- utes, the meter will turn itself off. You must remove the test strip and insert it back into the meter to restart the test.)

STEP 3

Accurate Results in Just 15 Seconds.

Your blood glucose test result will appear after the meter counts down from “15” to “1” second. Blood glucose test results are automatically stored in the meter memory. Turn the meter off by removing the test

strip.

(Example)

Record all test results in the Record book.

This helps you keep track of test results.

19

Image 29

Contents

Owner’s Booklet Page Owner’s Booklet 5.8 Dear PocketScan System Owner Page Important Information Table of Contents Using the Meter Memory Viii Getting Started PocketScan Blood Glucose Meter Test Port Target Area PocketScan Test StripsImportant Test Strip Information Coding the Meter Checking the DisplayMatch the Code Numbers Enter the Code ModeCode the Meter Checking the System with PocketScan Control Solution Do a control solution test Important Control Solution Test Information Insert Test Strip Result Appears in 15 Seconds Apply Control SolutionAt UK 0800 Republic of Ireland 1800 Comparing control solution resultsTesting Your Blood Cock the Penlet II Sampler Getting a Drop of BloodInsert a Lancet in the Penlet II Automatic Blood Sampler Remove the Lancet Wash Your HandsLance Your Finger Step-by-Step Test Procedure Accurate Results in Just 15 Seconds Apply SampleExample Special MessagesUsing the Meter Memory Recall Test Results Data Downloading Exit the Memory ModeResults References Batteries MaintenanceSymbol appears on the display Display Messages and PROBLEM- Solving Guide Message What IT Means Result. At the end of the count Message What IT Means Message What IT Means Action That Blood Sample was Tests were performed within This period Select the appropriate unit of measurement Probable Cause What to do Calibration Plasma/Serum Test Time 15 secondsAutomatic Shutoff Two minutes after last user action Operating RangesSet the Day Changing the DateSet the Year Set the Month Set the Minutes Changing the TimeSet the Hour Select mmol/L or mg/dL Exit the Setting ModePage Test Page 1998 Visit the LifeScan website at