Color profile: Disabled Composite Default screen
HINT
You may use the < and > keys to toggle between numbers when programming the area code.
NOTE
If you have no New Caller ID Messages, then the “New” display is blank. Only the “Total” display appears.
NOTE
Once a Caller ID message has been viewed, it is no longer considered a new message.
To change your Caller ID options:
1) Press and hold CALLER ID for two |
|
| |
1>Auto Talk:Off | |||
seconds. The following screen appears. | |||
2 CIDCW | :On | ||
| |||
| 3 Area Code: | ||
2)Use the : and ; keys to move the cursor to the selection that you would like to change. Press the SELECT key to toggle between On and Off for Autotalk and CIDCW. Press SELECT and use the number keypad to enter or change the area code, then press SELECT again. (You hear a confirmation tone indicating the area code has been changed.)
3)After you have made your selections, press CALLER ID and return the handset to the base. The STATUS LED flashes, indicating that your setup changes are now effective.
▼Screening Your Calls
Caller ID allows you to review caller information before you answer your phone. When the phone rings, the display shows the date, time, name, and phone number of the caller. If your Caller ID service is number only, then the name does not appear on the second line.
If a name or number is not available, the display will show a message such as Incomplete Data, Private Number, Private Name, etc.
▼Using CIDCW (Caller ID on Call Waiting)
1) During a call when you hear the Caller Waiting tone, check the handset for the name and number of the incoming caller.
2)Press FLASH to accept the incoming call. See page 22 for additional information.
27
C:...MPH6928 VA OM.vp Mon Feb 14 15:27:45 2000