Menu List ( Â)
The Menu list allows access to intercom calling, and personalization of handset including language, ring tone, vibrate, backlight and silent alert. Please refer to the section “Accessing Options on the Cordless Handset” on page 214.
Battery Charging
The handset is powered by a nickel metal hydride battery pack. To install and charge the battery:
1.Slide the cover of the battery compartment.
2.Place the battery pack in the compartment with the connector wires pointing towards the bottom of the handset.
3.Connect the battery terminal wire to the charging pins located in the compartment
4.Slide the cover of the battery compartment back onto the handset
5.Place the handset, face up, in the charging cradle. The handset should easily slide into the charging cradle. If it does not, check the battery compartment cover to ensure it is in the proper position.
6.To confirm that the battery is charging, check the battery icon symbol on the handset display to see if the lines inside the icon are flashing left to right.
Note: The battery must be charged for a minimum of six hours prior to initial usage of the phone.
Handset Battery Indicator & Status
The display provides "at a glance" information on the handset battery.
Icon | Description |
|
|
dcba | The bars indicate the battery charge level — 4 for full, needs recharging |
| when only 1 bar appear |
fThe bars flash when the battery is being recharged on the charger stand.
Note: The handset is designed to recharge the batteries automatically, when required and placed on the charger stand. The battery icon does not flash and the handset does not charge every time it is placed on the stand. If a defective battery is replaced, then the battery Icon is not identified until the new battery is charged for at least 2 minutes.
Accessing Options on the Cordless Handset
Model 6757i CT IP Phone User Guide | 225 |