Panasonic KX-TG5230AL 1Tone, Programmable Settings, Ringer Tone, Handset ringer tone Handset

TG5230AL.fm Page 17 Friday, June 11, 2004 5:31 PM

Programmable Settings

Base unit ringer volume Base Unit

Make sure the base unit is not being used.

To set the ringer volume to high (preset), medium, or low, press [d] or [B].

•To increase volume, press [B]. To decrease volume, press [d].

•To stop ringing, press [0].

To turn the ringer off, press and hold [d] until 2 beeps sound.

To turn the ringer on, press [d] or [B].

•The base unit will ring at the low level.

•You can adjust the ringer volume while an outside call is ringing. Press [d] or [B] while the base unit is ringing.

To turn the ringer off, press and hold [d] until 2 beeps sound.

Ringer Tone

You can set the handset and base unit ringers to use one of 7 ringer patterns for outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4” are melody patterns. The factory preset is “Tone 1”.

•You cannot change the ringer tone for intercom calls.

•If you select one of the melody ringer patterns, the ringer will continue to sound for several seconds if:

—the caller hangs up before you answer the call, or

—another person answers the call using another phone connected on the same line.

Handset ringer tone Handset

1Press [MENU].

2	Press the soft key (		) at “Ringer
		SELECT				Ringer setting
	setting”.
3	Scroll to “Ringer tone” by pressing [d] or
						Ringer tone
	[B], then press the soft key (				).
				SELECT
4	Select the desired ringer tone by pressing
						Ringer tone
	[d] or [B].					1:Tone 1
	• The handset will ring and the ringer tone will
	change. If the ringer volume has been turned off,
	the handset will not ring (p. 16).
	• You can also select the ringer tone by pressing
	[1] to [7].

Preparation

5Press the soft key ( SAVE ), then press [OFF].

17