EN
REMOTE SENSOR
To set up the remote sensor:
1.Slide open the battery compartment.
2.Slide channel switch to select channel 1.
3.Insert the battery, matching the polarities.
4.Press RESET after each battery change.
5.Close the battery compartment.
6.Place the sensor within 30 m (98 ft) of the main unit using the table stand or wall mount.
The transmission range may vary depending on many factors. You may need to experiment with various locations to get the best results.
NOTE We recommend that you use alkaline batteries with this product for longer usage and consumer grade lithium batteries in temperatures below freezing.
SENSOR DATA TRANSMISSION
Outdoor sensor:
The main unit will automatically search for the outdoor
sensor. The sensor reception icon in the remote sensor area shows the status:
ICON | DESCRIPTION |
|
|
| Main unit is searching for |
| sensor(s) |
|
|
| A channel has been found |
|
|
| The sensor cannot be |
| found. |
|
|
NOTE If the sensor is not found, check the batteries, obstructions, and remote unit location.
For best results:
•Place the sensor out of direct sunlight and moisture.
•Position the sensor so that it faces the main unit, minimizing obstructions such as doors, walls and furniture.
•Place the sensor in a location with a clear view to the sky, away from metallic / electronic objects.
•Position the sensor close to the main unit during cold winter months as
TIP Ideal placements for the sensor would be in any location on the exterior of the home at a height of not more than 1.5 m (5 ft) and which can shield it from direct sunlight or wet conditions for an accurate reading.
4