Important Safety Instructions for Battery Chargers

DeWalt DW008, DC011, DW9106 Important Safety Instructions for Battery Chargers, Charging Procedure

Charging Procedure

1.Plug the charger into an appropriate outlet.

SAVE THESE INSTRUCTIONS: This manual contains important safety and operating instructions.

•Before using charger, read all instructions and cautionary markings on (1) charger, (2) battery pack, and (3) product using battery pack.

DANGER: 120 volts present at charging terminals. Do not probe with conductive objects. Danger of electric shock or electrocution.

DANGER: If battery pack case is cracked or damaged, do not insert into charger. Electric shock or electrocution may result.

•DO NOT attempt to charge the battery pack with any chargers other than the ones in this manual. The charger and battery pack are specifically designed to work together.

•Do not expose charger to rain or snow.

•These chargers are not intended for any uses other than charging DEWALT rechargeable batteries. Any other uses may result in risk of fire, electric shock or electrocution.

•Pull by the plug rather than cord when disconnecting charger. This will reduce the risk of damage to the cord.

•Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

•Do not use an extension cord unless absolutely necessary. Use of improper extension cord could result in risk of fire, electric shock, or electrocution.

•An extension cord must have adequate wire size (AWG or American Wire Gauge) for safety. The smaller the gauge number of the wire, the greater the capacity of the cable, that is 16 gauge has more capacity than 18 gauge. When using more than one extension to make up the total length, be sure each individual extension contains at least the minimum wire size.

RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS

•Do not place any object on top of charger or place the charg- er on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is ventilated through slots in the top and the bottom of the housing.

•Do not operate charger with damaged cord or plug — have them replaced immediately.

•Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to an autho- rized service center.

•Do not disassemble charger; take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire.

•Unplug charger from outlet before attempting any cleaning. This will reduce risk of electric shock. Removing the battery pack will not reduce this risk.

•NEVER attempt to connect 2 chargers together.

•DO NOT store or use the tool and battery pack in locations where the temperature may reach or exceed 105°F (such as outside sheds or metal buildings in summer).

•The charger is designed to operate on standard household electrical power (120 Volts). Do not attempt to use it on any other voltage. This does not apply to the vehicular charger.

2.Insert the battery pack into the charger. Be sure the pack is fully seat- ed in the charger. The red (charging) light will blink continuously indi- cating that the charging process has started.

3.The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or left in the charger.

WARNING: Don't allow any liquid to get inside charger. Electric shock may result. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer.

Total Extension Cord Length (feet)

Wire Gauge