Lincoln Electric IM10023 manual Saving a Procedure to a Memory Location, Steel 1/8, Cc Dc +

Page 32

B-17	OPERATION	B-17

SAVING A PROCEDURE TO A MEMORY LOCATION

Once the parameters have been set:

•Press and Hold the Memory Button of the desired location for 2 seconds.

•The LED for that location will come ON.

•After 2 seconds the LED will go OFF

•The MSP display will show briefly that the informa- tion is saved, then return to the Weld Mode.

NOTE: Holding the button for longer than 5 sec- onds will enter the Limits Mode.

RECALLING A PROCEDURE FROM A MEMORY LOCATION

•Press and release the desired Memory Button.

•The LED for that location will come ON and the stored procedure information will show in the dis- plays.

•The LED will remain ON until another location is selected

NOTE: Holding the button for longer than 1 sec- ond will re-enter the “Save” Mode.

FIGURE B.8 - MEMORY

MSP

DISPLAY

LED

INDICATOR

MEMORY BUTTON

Hold for 2 Seconds

to Save

Press and Release

to Recall

200 30.5

58

Steel 1/8”

CC DC +

Memory 1

Saved

MAXsa™ 10 CONTROLLER

Image 32

Contents Controller Safety Electric Shock can kill Welding and Cutting Sparks can Cause fire or explosion Précautions DE Sûreté Thank You Table of Contents Installation Technical Specifications MAXsa 10 ControllerSafety Precaution Figure A.1 MAXsa 10 Connections Interfacing to the MAXsa 10 CON TrollerFigure A.3 Figure A.4 Controlling NON-LINCOLN Equipment Shutdown Inputs Stop InputFigure A.6 Connection Diagram Single ARC System Safety Precautions Design FeaturesOperation Definitions of Welding ModesRecommended Processes and Equipment General Physical DescriptionGeneral Functional Description Common Basic Equipment Packages200 Setting Feed FORWARD/REVERSE POWER-UP SequenceWire Feeder Setup Changing and Setting Weld Modes Frequency AdjustBalance Adjust Offset AdjustWeld Mode Searching Searching for a Weld ModeMultiple ARC Configuration Table B.1 Phase Relationship ARCArc Delay Time Weld SequenceStart Options Operation Start OptionsDownslope Time END OptionsEND Options Operation Accessing the Setup Menu Access Preference ChangeParameter Definition Preference SelectionUser Defined Parameters Wire Drive Gear Ratio 100 View Diagnostics?Parameter Definition Hot-Inch Touch Sense Option Shutdown 2 Function Select107 View Power Source Protocol Parameter Definition 101 View Event Logs102 View Fatal Logs 103 View Software Version Information503 Memory Button Disable 504 Mode Select Panel Lock505 Setup Menu Lock Parameter Definition 502 Memory Change LockoutParameter Definition 506 Set User Interface Passcode 509 UI Master LockoutTouch Sense Lockout / SecurityMaking a Weld Figure B.7 Making a WeldMulti Procedure Welding Using the Memory OptionNaming a Saved Procedure Saving a Procedure to a Memory Location Recalling a Procedure from a Memory LocationSteel 1/8 CC DC +Optional Limit Setup Setting LimitsAccessories Follow these stepsPeriodic Maintenance Calibration Specification MaintenanceRoutine Maintenance Troubleshooting HOW to USE Troubleshooting GuideUsing the Status LED to Troubleshoot System Problems Table E.1Arclink System Error Codes Troubleshooting Verify correct sense lead connection Output Disabled Output Problems Troubleshooting Diagrams Enhanced DiagramDimension Print L13444Precaucion Warnung