Lincoln Electric IM10023 Routine Maintenance, Periodic Maintenance Calibration Specification

Page 35

D-1	MAINTENANCE	D-1

SAFETY PRECAUTIONS

WARNING

ELECTRIC SHOCK can kill.

•Do not touch electrically live parts such as output terminals or internal

wiring.

•When inching, electrode and drive mechanism are “hot” to work and ground and could remain energized several seconds after the inch but- ton is released.

•Turn OFF input power at welding power source before installation or changing drive roll and/or guide tubes.

•Welding power source must be connected to system ground per the National Electrical Code or any applicable local codes.

•Only qualified personnel should perform mainte- nance work.

------------------------------------------------------------------------

See additional warning information throughout this operator’s manual and the Engine manual as well.

------------------------------------------------------------------------

ROUTINE MAINTENANCE

•Check weld cables, control cables and gas hoses for cuts.

PERIODIC MAINTENANCE

• N/A

CALIBRATION SPECIFICATION

All calibration is factory set on the MAXsa™ 10 CON-

TROLLER.

MAXsa™ 10 CONTROLLER

Image 35

Contents Controller Safety Electric Shock can kill Welding and Cutting Sparks can Cause fire or explosion Précautions DE Sûreté Thank You Table of Contents Technical Specifications MAXsa 10 Controller InstallationSafety Precaution Figure A.1 MAXsa 10 Connections Troller Interfacing to the MAXsa 10 CONFigure A.3 Figure A.4 Controlling NON-LINCOLN Equipment Stop Input Shutdown InputsFigure A.6 Connection Diagram Single ARC System Definitions of Welding Modes Safety PrecautionsDesign Features OperationCommon Basic Equipment Packages Recommended Processes and EquipmentGeneral Physical Description General Functional Description200 Setting Feed FORWARD/REVERSE POWER-UP SequenceWire Feeder Setup Offset Adjust Changing and Setting Weld ModesFrequency Adjust Balance AdjustTable B.1 Phase Relationship ARC Weld Mode SearchingSearching for a Weld Mode Multiple ARC ConfigurationStart Options Arc Delay TimeWeld Sequence Start Options OperationDownslope Time END OptionsEND Options Operation Preference Selection Accessing the Setup MenuAccess Preference Change Parameter DefinitionUser Defined Parameters Shutdown 2 Function Select Wire Drive Gear Ratio100 View Diagnostics? Parameter Definition Hot-Inch Touch Sense Option103 View Software Version Information 107 View Power Source ProtocolParameter Definition 101 View Event Logs 102 View Fatal LogsParameter Definition 502 Memory Change Lockout 503 Memory Button Disable504 Mode Select Panel Lock 505 Setup Menu LockLockout / Security Parameter Definition 506 Set User Interface Passcode509 UI Master Lockout Touch SenseFigure B.7 Making a Weld Making a WeldMulti Procedure Welding Using the Memory OptionNaming a Saved Procedure CC DC + Saving a Procedure to a Memory LocationRecalling a Procedure from a Memory Location Steel 1/8Setting Limits Optional Limit SetupFollow these steps AccessoriesPeriodic Maintenance Calibration Specification MaintenanceRoutine Maintenance HOW to USE Troubleshooting Guide TroubleshootingTable E.1 Using the Status LED to Troubleshoot System ProblemsArclink System Error Codes Troubleshooting Verify correct sense lead connection Output Disabled Output Problems Troubleshooting Enhanced Diagram DiagramsL13444 Dimension PrintPrecaucion Warnung