Lincoln Electric IM10023 Parameter Definition Hot-Inch Touch Sense Option, Wire Drive Gear Ratio

B-11	OPERATION	B-11
	USER DEFINED PARAMETERS (CONT.)
Parameter	Definition
P.15	Hot-Inch Touch Sense Option

This option allows enabling or disabling touch sense when feeding wire forward.

Disabled = Touch sensing is disabled when feeding the wire forward (default).

Enabled = Touch sensing is active when feeding the wire forward.

	When enabled and feeding wire forward, the wire is electrically "hot" and waiting to short to the
	plate. When a short occurs, the wire feed automatically stops and the flux hopper relay is acti-
	vated until the feed forward button is released.
P.18	Wire Drive Gear Ratio
	This option selects the Wire Drive Gear Ratio that will be used. This applies to the Cruiser dX
	Tractor and MAXsa 10 only. The possible selectable values are read from the Wire Drive on
	startup.
	Note: Changing this value will cause the system to reset.
P.21	Shutdown 2 Function Select
	This option allows selection of the Shutdown 2 input function on the control box. Normal
	Shutdown = The Shutdown 2 input functions as a standard shutdown input that locks out all
	input buttons (default) Output Disable = The Shutdown 2 input functions as a machine output
	lockout to disable the welding circuit but still allow cold feeding of the wire.
P.23	Trigger Fan-Out
	For Sub-Arc Lead Arc machines only. Allows the Lead Arc MAXsa10 to control all machine trig-
	gers in a multi-arc system.
	No = Only the machine connected to the MAXsa10 can be triggered on and off (default).
	Yes = All machines in the system can be triggered on and off simultaneously.
P.30	Input Control
	This option allows the front panel controls of the MAXsa 10 to be enabled/disabled. The remote
	inputs are always functional when connected, but there may be applications where it is neces-
	sary to disable the inputs on the pendent. Panel & Remote = All pendent buttons are enabled
	(default). Panel Locked = The Start, Flux and feed buttons are disabled at the pendent. The
	pendent's Stop button is always active and cannot be disabled.
P.80	Sense From Studs
	Use this option for diagnostic purposes only. When power is cycled, this option is automatically
	reset to False.
	False = Voltage sensing is automatically determined by the selected weld mode and otherma-
	chine settings (default).
	True = Voltage sensing is forced to "studs".
P.99	Show Test Modes?
	Most power sources contain weld modes used for calibration and test purposes. By default, the
	machine does not include test weld modes in the list of weld modes that are available to the
	operator. To manually select a test weld mode, set this option to "Yes". When the power source
	is turned off and back on again, the test modes will no longer appear in the mode list. Test weld
	modes typically require the machine output to be connected to a grid load and cannot be used
	for welding.
P.100	View Diagnostics?
	Diagnostics are only used for servicing or troubleshooting the Power Wave system. Select "Yes"
	to access the diagnostic options in the menu. Additional parameters will now appear in the
	setup menu (P.101, P.102, etc).
	MAXsa™ 10 CONTROLLER