Omega Engineering JD 4045, 185-210 DUS manual Maintenance Schedule Chart, 25 P/N

4.17 MAINTENANCE SCHEDULE CHART

INTERVAL		REQUIRED MAINTENANCE	REFERENCE
	1.	Check compressor system fluid level.
EVERY 10	2.	Check radiator coolant level in coolant recovery tank.
	3. Check fuel supply after running.
HOURS OR	4.	Check air filter maintenance indicator (if equppied).
DAILY	5.	Check for fuel, oil, air, and water leaks.
	6.	Check battery mounting for security.
	7.	Drain water and sediment from fuel tank.	Drain at bottom of tank.
EVERY 50	1.	Clean return line orifice after initial start only.
	2.	Drain water from compressor oil reservoir. More frequent	Drain at bottom of reservoir.
HOURS OR
	draining may be required under high humidity conditions.
WEEKLY
	3.	Inspecting lifting frame (and before each lift).
	1.	Change air end fluid and fluid filter elements.
	2.	Clean battery terminals, check battery hold-downs and
EVER 500	cables for wear.
	3.	Check air filter piping, fittings, and clamps.
HOURS
	4.	Check radiator hoses and clamps.
	5.	Check engine and air end mounts.
	6.	Check fan belt tension.
	1.	Install new air filter elements (shorter intervals may be
	necessary under dusty conditions).
	2.	Check all door gaskets, hinges, and latches to maintain
EVERY 1000	acoustics seal.
	3.	Drain engine radiator coolant. Clean and flush cooling
HOURS
	system. Refill with coolant.
	4.	Check engine and compressor shut down switches.
	5.	Check reservior pressure relief valve.
	6.	Install new fuel filter and water separator elements

NOTICE: Check engine operator’s manual for required service and service intervals.

25 P/N: 307271