Omega Engineering 185-210 DUS, JD 4045 manual Servicing, Lifting

Page 9

1.4 SERVICING

1.Before servicing compressor, relieve receiver pressure and allow to cool.

2.Be sure all access panels are opened and/or removed.

3.Wipe up all spills resulting from servicing.

4.Disconnect the grounded (negative) battery connection before making repairs or cleaning inside the enclosure.

5.Do not use flammable solvents for cleaning the compressor.

6.Radiator coolant is under pressure. Do not remove radiator cap quickly, it may cause spray of scalding coolant and severe burns to operator.

7.Make repairs only in clean, dry and well-lighted and well-ventilated areas.

8.Keep all parts of the body and any hand held tools or other metal objects away from exposed live parts of the electrical system.

9.Replace damaged fuel tanks or lines immediately. DO NOT WELD on or near fuel tanks or lines.

10.Make sure all personnel are out of the compressor before closing and/or replacing panels.

1.5 LIFTING

1.If the compressor is provided with a lifting bail, then lift by the bail. If no bail is provided, then lift by sling.

2.When lifting by helicopter, use a sling. Do not lift by unit lifting bail.

3.Inspect the entire lifting, rigging and supporting structure to ensure it is in good condition and has a rated capacity of at least the gross weight of the compressor plus 50%.

10

P/N: 307271

Image 9

Contents Serial Number Model Number 06/17/2008 MCM Omega ToolPage Table of Contents Page OWNER’S Responsibility Introduction AIR Compressor Safety Precautions Tampering with Noise Control System Prohibited User ModificationParking SafetyBefore Starting the Compressor Compressor USE and Compressed AIRLifting ServicingDescription IntroductionRotary Compressor Components Engine Components Enclosure ChassisInstrument Panel Door FrameEmergency Shutdown Procedure Starting ProcedureRoutine Shutdown Procedure OperationEngine Fuel Specifications MaintenanceCold Weather Fuel 15 P/NOIL Filter Replacement Engine Cooling SpecificationsEngine OIL and Filter MixturesRadiator Radiator Pressure CAPCompressor OIL Coolant LevelCompressor OIL Specifications 19 P/N Compressor OIL FilterCompressor & Engine AIR Filter Maintenance Element ReplacementElement Inspection Cleaning Oilthermostat Belts & Belt AdjustmentSeparator Element Replacement Compressor OIL Thermostatic ValveCONTROLS-OPERATION and Adjustments AdjustmentIdle Speed Adjustment Procedures Pressure Regulator Adjustment BatteryRated Speed Adjustment InstrumentsDaily Operation Maintenance Schedule25 P/N Maintenance Schedule ChartCompressor AIR Filter Element Procedure for Ordering PartsTroubleshooting Troubleshooting27 P/N Symptom Cause Remedy Troubleshooting Chart29 P/N Clean or replace the element Warranty Boss INDUSTRIES, INC Genesis Drive LAPORTE,31 P/N Summary of Main Warranty Provisions Warranty Claims Preparation of Part Return WARRANTY/RETURN Goods InstructionsReturn or Warranty Claims Filing Procedures 33 P/NDamage in Transit General35 P/N Screw Compressor AIR-END Exchange ProgramPage 37 P/N Section Assembly DrawingsEngine & PARTS, Omega 185-210 DUS Frame & PARTS, Omega 185-210 DUSCompressor & PARTS, Omega 185-210 DUS Coolers & PARTS, Omega 185-210 DUSREV Description Date ENG Revision History 39 P/NSWITCH, Press 18# N.O /8MNPT BRACKET,ASSY ENG. AIR CleanerSWITCH, Temp 220 F NC Gold Contacts SENDER, Coolant Temperature 3/841 P/N 307271 CONNECTOR, Male 1/4 T X 1/4 D CONNECTOR, 1 Mjic X 1 MnptCONNECTOR, 1/4 Mnpt X 1/4 Tube 200PSI DEG RELIEF, 1/2 NPT 175 PSIBOLT, Battery Hold Down BRACKET, Battery Hold DownBATTERY, 12VOLT 650CCA a VALVE, Service 1 X 3/4-Y VentedLA PORTE, 45 P/NPANEL, DUS OIL Fill Access PANEL, DUS Rear AccessLatch ADJ Lever C2-33-35 WASHER, Flat Wide 1/4 SS47 P/N John Deere 4045 DF Engine