Bosch Power Tools 3924 Miter Scale Vernier Indicator Adjustment, Crown Molding Detent Adjustment

Adjustments

Miter Scale (Vernier) Indicator

Adjustment

1.Raise the head assembly to the full-up position.

2.Through the slot 1 in the kerf insert, loosen the Phillips screw 2 that holds the indicator 3 in place (Figure 12).

3.Position the indicator 3 to align with the 0° miter mark 4. Tighten the screw 2.

Crown Molding Detent

Adjustment (Bevel)

1.Move sliding fence to proper position. (See Sliding Fence on page 54.)

2.Push detent stop pin 5 completely in as shown in (Figure13).

! CAUTION	Keep pin in out position for all operations
	except when cutting crown molding.

3.Loosen bevel lock handle 6. Rotate head assembly until the stop pin 5 rests on top of the crown molding adjustment bolt 8 and the pointer is indicating 33.9° on the bevel scale. Tighten the bevel lock handle 6 (Figure 13).

4. Measure the angle between the blade and the table. If it FIG. 13 is not 33.9° follow the procedures for the crown molding

detent adjustment.

Crown Molding Detent Adjustment

a.Loosen jam nut 7 with the wrench provided.

b.Loosen bevel lock handle 6.

c.Turn crown molding adjustment bolt 8 with the wrench provided until blade aligns a the square at 33.9°.

d.Tighten bevel lock handle 6.

e Tighten jam nut 7.

45

40	1
35
	316
	30
	25
	225
	20
	15
	10
	5
	0
	5
	10
	15
	20
	25
	30
	35
40

FIG. 12

2

4

3

8

5

6

7

42