RZ 2610925600 9-05 9/1/05 11:04 AM Page 17
Functional Description and Specifications
!WARNING Zipmate attachment must be used only with an hard auxiliary control side handle. Two handed control of solid gripping handles will provide
sufficient control of the cutting wheel in case of recoil.
!WARNING Disconnect battery pack from tool or place the switch in the locked or off position before making any assembly, adjustments or changing
accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
Zipmate® Abrasive Cut Off Attachment
WHEEL GUARD | WHEEL GUARD | |
LOCK LEVER | ||
|
FIG. 1 | GUARD | |
LOCK LEVER | ||
| ADJUSTMENT | |
| SCREW | |
LOCK LEVER |
| |
ADJUSTMENT | ABRASIVE | |
SCREW | ||
WHEEL | ||
| ||
LOCK |
| |
LEVER | SHAFT LOCK |
Recommended for use with: Rebel, Revolution, and all RZ model Spiral Saws.
!WARNING Hard auxiliary control handle must be obtained for models RZ1 and RZ25. Call
Note : The speed of your tool will be reduced 2 : 1 when using your Abrasive
Assembly
! | WARNING | Always | use | auxiliary | |
handle | for | maximum | |||
|
|
control over torque reaction or
REMOVING AND INSTALLING
ABRASIVE CUT OFF ATTACHMENT Disconnect battery pack from tool or place the
switch in the locked or off position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Make certain that the collet nut is securely tightened before turning the tool on.
1.Insert the 1/4” collet into the collet nut. Loosely thread the collet nut onto the output shaft (Fig. 2).
2.Insert drive bit into the collet until it stops, and securely tighten the collet nut with the wrench.
3.Open locking lever and position attachment onto the collar. Note: It may be necessary to rotate attachment slightly and hold both the tool and attachment shaft locks to engage square end of drive bit into attachment.
4.Position attachment as shown and lock the clamp lever.
Use the allen wrench to adjust the lock lever adjustment screw.