Ryobi P500 manual Operation, Applications, Installing the Battery Pack, Removing the Battery Pack

WARNING:

Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could re- sult in objects being thrown into your eyes, resulting in possible serious injury.

APPLICATIONS

You may use this tool for the following purposes:

Cutting all types of wood products (lumber, plywood, paneling)

Cross Cutting/Rip Cutting

Bevel Cutting

Pocket Cutting

This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs.

For complete charging instructions, refer to the Operator’s Manual for the battery packs and chargers listed in the General Safety Rules.

INSTALLING THE BATTERY PACK

See Figure 4.

nPlace the battery pack in the saw. Align the raised rib on the battery pack with the groove inside the saw, then slide the battery pack into the saw.

nMake sure the latches on each side of your battery pack snap into place and the battery pack is secured in the saw before beginning operation.

DEPRESS LATCHES TO REMOVE BATTERY PACK

TO

INSTALL

BATTERY

PACK

Fig. 4

CAUTION:

When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.

REMOVING THE BATTERY PACK

See Figure 4.

nLocate the latches on the side of the battery pack and depress them to release the battery pack from the saw.

nRemove battery pack from your saw.