Cabletron Systems TRMMIM manual Virus Disclaimer

Page 3

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

Virus Disclaimer

Cabletron has tested its software with current virus checking technologies. However, because no anti- virus system is 100% reliable, we strongly caution you to write protect and then verify that the Licensed Software, prior to installing it, is virus-free with an anti-virus system in which you have conﬁdence.

Cabletron Systems makes no representations or warranties to the effect that the Licensed Software is virus-free.

Copyright © 1996 by Cabletron Systems, Inc. All rights reserved.

Printed in the United States of America.

Order Number: 9031130-E6 October 1996

Cabletron Systems, Inc.

35 Industrial Way, P.O. Box 5005

Rochester, NH 03867-0505

SPECTRUM, MiniMMAC, FNB, Multi Media Access Center, and DNI are registered trademarks, and Portable Management Application, IRM, IRM2, IRM3, IRBM, ETSMIM, EFDMIM, EMME, ETWMIM, FDMMIM, FDCMIM, MRXI, MRXI-24,NB20E, NB25E, NB30, NB35E, SEHI, TRBMIM, TRMM, TRMMIM, TRXI, Media Interface Module, MIM, and Flexible Network Bus are trademarks of Cabletron Systems, Inc.

UNIX and OPENLOOK is a trademark of Unix System Laboratories, Inc. OSF/Motif and Motif are trademarks of the Open Software Foundation, Inc. X Window System is a trademark of Massachusetts Institute of Technology. Ethernet and XNS are trademarks of Xerox Corporation. Apple and AppleTalk are registered trademarks of Apple Computer, Inc. Banyan is a registered trademark of Banyan Systems, Inc. DECnet is a registered trademark of Digital Equipment Corporation. Novell is a registered trademark of Novell, Inc. CompuServe is a registered trademark of CompuServe. Sun Microsystems is a registered trademark, and Sun, SunNet, and OpenWindows are trademarks of Sun Microsystems, Inc.

i

Image 3

Contents Trmmim Page Virus Disclaimer Applicable to licenses to the United States Government only Restricted Rights NoticeContents Chapter Alarm Conﬁguration Chapter Ring MapChapter Statistics Appendix a Trmmim MIB Structure Chapter Ring Security ConﬁgurationContents Trmmim Using the Trmmim User’s GuideIntroduction to Spma for the Trmmim What’s not in the Trmmim GuideScreen Displays ConventionsIntroduction to Spma for the Trmmim Button Using the MouseFTP Getting HelpTrmmim Firmware Introduction to Spma for the Trmmim Trmmim Firmware Using the Hub View Using the Trmmim Hub ViewNavigating Through the Hub View Using the Trmmim Hub ViewTrmmim Hub View Hub View Front PanelDevice Location UptimeTime and Date Device NameUsing the Trmmim Hub View Using the Mouse in a Hub View Module Module Index FNB Bypass State Port Display Form Hub View Port Color CodesPort Type ErrorsFrames Total BytesFNB Display Monitoring Hub Performance Using the Trmmim Hub View Name and Location Checking Device Status and Updating Front Panel InfoTotal Rings Checking Module StatusContact Date and TimeModule Speed FaultSpeed Fault Location Module NameModule/Port Admin StateChecking Port Status Port NameChecking Station Status Link State TimeInsertion Trap Station Name VendorUpstream Neighbor/Downstream Neighbor Reverse MACs Physical LocationPriority Port MappingConﬁguring Station Name, Location, or Priority Checking Ring Port StatusMedia Type Fault State TimeMedia Fault ClassChecking Statistics Abort BytesLine BurstManaging the Hub Managing the Hub at the Device LevelFind MAC Address 12. The Find MAC Address Window Setting the Polling IntervalsContact Status 13. Trmmim Polling IntervalsStatistics Device General StatusDevice Conﬁguration Port Operational StateControlling Token Ring FNB Multiplexer Connections Managing the Hub at the Module LevelINS Bypass BoardLeft Connect Right ConnectClearing the Module FNB Conﬁguration Window Selections Controlling Token Ring SpeedManagement MGT Controlling Token Ring MIM Management ModeEnabling All Ports on Token Ring Modules Auto AUTManaging the Hub at the Port Level Converting a Station Port to a Ring-out PortEnabling and Disabling Station and Ring Ports Removing a Station from the Ring Ring Map From the Hub View From the command line stand-alone modeLaunching the Ring Map From the iconRing Name Selecting a Ring to MapRing Map Utilization SpeedStations NameQuick Info Popup Window Viewing Station-speciﬁc InformationDrop Board and PortPerformance and Errors Setting a Station NameViewing Management Station Conﬁguration Setting a Station DropCommands Open Status Error StatusActive Monitor ErrorSetting the Statistics Calculation Mode Error Report TimerViewing Ring-level Information Set Calculation Mode Window Viewing the Error TableError Table Window Isolating Errors Total ErrorsNon-Isolating Errors Changing the Station Labels Viewing Device Information Device Information Window Setting the Map Poll IntervalBeacon Events Viewing Beacon HistoryActive Monitor Changes Ring PurgesLast Beacon Type Longest BeaconLast Beacon Beacon Conﬁguration 12. The Beacon Conﬁguration Window Using the Find Options 13. Sample Find Windows Searching by Station Name, MAC Address, Board/Port, or DropFinding the Active Monitor on the Network Finding the Management Station on the Network Frames or Errors measured/Δ Time in seconds 14. Sample Find Highest and Lowest Windows Accessing Other Spma ApplicationsAlarm Conﬁguration Spmarun e5alarms IP address community name Setting and Viewing Ring Alarms Alarm Conﬁguration Setting a Ring Level Alarm Setting and Viewing Station AlarmsAlarm Conﬁguration Alarm Conﬁguration Alarm Conﬁguration Setting a Station Level Alarm Alarm Conﬁguration Setting and Viewing Station Alarms Statistics Using StatisticsSpmarun e5stats IP Address community name Viewing the Ring Station ListDownstream Addr Module and PortStn Name Upstream AddrUsing the Reverse MAC Button Monitoring Ring and Station StatisticsRefreshing the Station List Creating a Pie Chart Creating a Graph or Meter Click mouse button 1 on KBytes Ring and Station VariablesGeneral ProtocolsAC Error Isolating ErrorsLine Errors Burst ErrorNon-Isolating Errors Abort ErrorInternal Error Frequency Errors Token ErrorsStatistics Ring and Station Variables About Ring Security Ring Security ConﬁgurationRing Security Conﬁguration Launching the Security Conﬁguration WindowSecurity Conﬁguration Ring Selection window, -1, will appear Disallowed Count Allowed Station ListAllowed Count Disallowed Station ListSecurity Mode Options Disable SecurityEnable Security Allowed/Disallowed List Conﬁguration Buttons Building the Allowed List Automatically Conﬁguring SecurityStation Addition Window Deleting Stations from the Allowed or Disallowed ListsClear List Window Clearing All Entries in the Allowed or Disallowed ListRemove Changing the Ring Security ModeTrmmim MIB Structure Ietf MIB SupportNetwork One, Network Two Chassis MGRProtocol Stack Snmp AgentTelnet Brief Word About MIB Components and Community NamesTrmmim MIB Structure Index Index-2 Index-3 Index-4