Vicks PS-0K, PS-3K, PS-1K Installing the stud holder in the Stud Welding Pistol

Page 25

R

Setting the Stud Welder Pistol

4.2Installing the stud holder in the Stud Welding Pistol

The following diagram shows how the stud holder is installed in the Stud Welding Pistols PS-1 and PS-3K. The Stud Welding Pistols PS-0K and PS-1K are equipped with a support tube instead of the pistol feet (1).

1 2 3 4 5

6

SZ05.0693.010.X

1	Pistol foot	4	Bellows
2	Stud holder	5	Spring shaft
3	Union nut	6	Stud flange

•Loosen union nut (3) on Stud Welding Pistols PS-1 and PS-3K using the socket spanner SW 17; for Stud Welding Pistols PS-0K and PS-1K socket spanner SW 14 is required.

•Push stud holder (2) into the spring shaft (5) until it stops.

•Fix stud holder (2) into position with union nut (3).

NOTE

The stud flange must project over the pistol feet tips and the support tube by the dimension of the flange thickness. If necessary, remove stud holder and correct projection by adjusting the stop screw.

4-18

Image 25

Contents PS-3K PS-0K PS-1K PS-3K PS-0K PS-1K GmbH Page Table of Contents Maintenance Setting the Stud Welding PistolInitiation Quality controlSpare parts Following should be principally observed General informationIntended use Chapters of Operating Instructions Information on the documentationReaction in the case of malfunctions Information on Operating InstructionsTechnology of tip ignition Description of the Stud Welding PistolsStud Welding Pistol PS-1 Stud Welding Pistol PS-3K Stud Welding Pistol PS-0K PS OMStud Welding Pistol PS-1K PS-1 PS-3K PS-0K PS-1K Technical dataCharacterisation of references in the Operating Instructions Safety instructionsStaff qualification and training Safety-conscious workingFollowing should be observed prior to initiation Safety instructions for the User/OperatorBefore starting welding operations Safety measures at the installation siteIndependent retrofitting and spare parts production Working with the Stud WelderNon-permissible operating modes Setting the Stud Holder Setting the Stud Welding PistolInstalling the stud holder in the Stud Welding Pistol Spring pressure Setting the spring pressureGeneral view InitiationOperation Connecting the Stud Welding Pistols to the Stud WelderStud Welder BMS-660-90 Welding parametersStud Welder BMS-690-135 Stud Welder BMS-8H Stud Welder BMS-6HQuality Control Type and scope of testingGeneral information Demands on the companyNormal work test Implementation of sample takingSimplified work test Production of samplesBending test Tension testStud Welding Pistols MaintenanceReplacing components Spare parts Spare parts list for Stud Welding Pistol PS-1Perspective presentation of Stud Welding Pistol PS-1 Spare parts list for Stud Welding Pistol PS-3K Perspective presentation of Stud Welding Pistol PS-3K Spare parts list for Stud Welding Pistol PS-0K Perspective presentation of Stud Welding Pistol PS-0K Spare parts list for Stud Welding Pistol PS-1K Perspective presentation of Stud Welding Pistol PS-1K Troubleshooting Functional breakdowns Standards and List of Directives Warranty TermsHeinz Soyer Bolzenschweißtechnik GmbH