Miller Electric XMS 4000 manual Maintenance & Troubleshooting, Months

Page 29

SECTION 5 − MAINTENANCE & TROUBLESHOOTING

5-1.	Routine Maintenance
		Y Disconnect power	. Maintain more often
		before maintaining.	during severe conditions.
		3 Months
	Replace	Repair Or	Replace Cracked
	Damaged Or	Replace	Replace Cracked
	Unreadable	Cracked	Torch Body
	Labels	Cables
			Repair Or Replace
			Cracked Cables
			And Cords
			Clean
			And
			Tighten Weld
			Connections
		6 Months
	Blow Out Inside		Replace
			Cracked
			Hoses
	Blow Out Heat		Change
	Exchanger Fins		Coolant (If
			Using Water)
		12 Months
		Change Coolant (If
		Using MILLER Coolant)

OM-224 043 Page 25

Image 29

Contents Xmsr From Miller to You Table of Contents Declaration of Conformity for European Community CE Products Arc Welding Hazards Symbol UsageMarks a special safety message Magnetic Fields can affect pacemakers ARC Rays can burn eyes and skinFire or Explosion hazard California Proposition 65 WarningsAbout Pacemakers Principal Safety StandardsEMF Information Manufacturer’s Warning Label Definitions − Definitions60 s 100 h. std I1eff Manufacturer’s Rating Labels Symbols And DefinitionsI1max Duty Cycle And Overheating − InstallationSpecifications Volt-Ampere Curves Remove wire spool Turntable ScrewMovement Do not move or operate unit where it could tip Dimensions and WeightSelecting a Location LocationRemote 7 Receptacle Information TIG And Stick Only Weld Output Terminals And Selecting Cable SizesARC Welding can cause Electromagnetic Interference 120 mFilling Coolant Tank Circuit BreakersConnecting Input Power Electrical Service Guide50/60 Hz Three Phase = GND/PEFront Panel Controls − OperationWelding Process Selection Switching On the Unit and Recalling Factory ParametersBe aware that the wire type selection is Gas Selection in Synergic MIG or Synergic Pulsed MIG Welding Trigger Mode Selection TIG and Stick OnlySetting Menu Type TIG and Stick only Setup Push Button And Advanced ProgrammingSetting Cooler Status During SettingPreparing Unit For MIG Welding Selecting Manual MIG WeldingDuring Synergic MIG Welding Setting Cooler Status see SectionSelecting Synergic MIG Welding Selecting Synergic Pulsed MIG Welding Setting Postflow only in Menu Full Setting Initial And Final Amperage only in Menu FullSetting Cooler Status only in Menu Full Preparing Unit For TIG WeldingPreparing Unit For Stick Welding TIG Lift-Arc WeldingMonths − Maintenance & TroubleshootingHelp Displays Do not remove case when blowing out inside of unitBlowing Out Inside Of Unit Is displayed TroubleshootingSoftware problems OM-224 043 − Electrical Diagram Unit Outer Assembly − Parts ListDia Part Description Quantity Mkgs Unit Main Assembly CR5,6,R1 Page Effective January 1 ITW Welding Products Italy S.r.l. Via Privata Iseo, 6/E Owner’s Record