Miller Electric XMS 4000 manual Selecting a Location, Dimensions and Weight

Page 15

3-5. Selecting A Location

Dimensions and Weight

86 kg

1020 mm

830 mm

490 mm

Location

3

500 mm

500 mm

Movement

YDo not move or operate unit where it could tip.

1 Lifting Handles

Do not use handle to lift unit.

2 Rating Label

Use label to determine input power needs.

3 Line Disconnect Device

Locate unit near correct input power supply.

YSpecial installation may be required where gasoline or volatile liquids are present − see NEC Article 511 or CEC Section 20.

2

500 mm

500 mm

OM-224 043 Page 11

Image 15
Contents Xmsr From Miller to You Table of Contents Declaration of Conformity for European Community CE Products Symbol Usage Marks a special safety messageArc Welding Hazards Magnetic Fields can affect pacemakers ARC Rays can burn eyes and skinFire or Explosion hazard California Proposition 65 WarningsPrincipal Safety Standards EMF InformationAbout Pacemakers Manufacturer’s Warning Label Definitions − Definitions60 s 100 h. std Manufacturer’s Rating Labels Symbols And Definitions I1maxI1eff − Installation SpecificationsDuty Cycle And Overheating Volt-Ampere Curves Remove wire spool Turntable ScrewLocation Dimensions and WeightMovement Do not move or operate unit where it could tip Selecting a Location120 m Weld Output Terminals And Selecting Cable SizesRemote 7 Receptacle Information TIG And Stick Only ARC Welding can cause Electromagnetic InterferenceFilling Coolant Tank Circuit Breakers= GND/PE Electrical Service GuideConnecting Input Power 50/60 Hz Three PhaseFront Panel Controls − OperationWelding Process Selection Switching On the Unit and Recalling Factory ParametersBe aware that the wire type selection is Gas Selection in Synergic MIG or Synergic Pulsed MIG Welding Trigger Mode Selection TIG and Stick OnlySetting Menu Type TIG and Stick only Setup Push Button And Advanced ProgrammingSelecting Manual MIG Welding During SettingSetting Cooler Status Preparing Unit For MIG WeldingSetting Cooler Status see Section Selecting Synergic MIG WeldingDuring Synergic MIG Welding Selecting Synergic Pulsed MIG Welding Preparing Unit For TIG Welding Setting Initial And Final Amperage only in Menu FullSetting Postflow only in Menu Full Setting Cooler Status only in Menu FullPreparing Unit For Stick Welding TIG Lift-Arc WeldingMonths − Maintenance & TroubleshootingDo not remove case when blowing out inside of unit Blowing Out Inside Of UnitHelp Displays Troubleshooting Software problemsIs displayed OM-224 043 − Electrical Diagram Unit Outer Assembly − Parts ListDia Part Description Quantity Mkgs Unit Main Assembly CR5,6,R1 Page Effective January 1 ITW Welding Products Italy S.r.l. Via Privata Iseo, 6/E Owner’s Record