38 en Installing a Wall Mount | AutoDome Junior HD |
|
|
5.1.3Preparing the Wall Mount for an Outdoor
Installation
The following instructions detail the surface preparations and the steps to install the Wall Mount for an outdoor application.
1.Determine a secure location for the wall mount (supplied separately).
NOTICE!
The fasteners and mounting surface must be capable of supporting a maximum load of 11.33 kg (25 pounds).
366.0
(14.1)
333.0
(13.11)
220.4
(8.68)
291.0
(11.46)
Figure 5.4 Wall Mount Dimensions
2.Use the four (4) holes at the end of the Wall Mount as a template to mark the position where the holes should be drilled to secure the mount.
3.Drill the four (4) holes in the installation location, screws not supplied. Use a minimum screw length of 10 mm (.39 in.).
4.Drill a fifth hole (maximum of 20 mm) in the center of the
5.Ensure that the gasket is attached to the retaining ring. If the gasket and the retaining ring are separate:
F.01U.275.803 6.0 2012.11 | Installation Manual | Bosch Security Systems, Inc. |