58 en Installing a Recessed Mount | AutoDome Junior HD |
| |
5.Attach the retaining ring with gasket (item 2, below, supplied with the AutoDome Junior camera) to the VJR-A3- JW. Ensure that the side of the retaining ring with the counter-sunk screw holes is facing you.
Figure 6.12 O-ring and retaining ring placement for outdoor installation
1M3 – .5 x 6 Phillips flat head machine screws
(supplied with AutoDome Junior Camera)
2Retaining ring with gasket
(supplied with AutoDome Junior Camera)
6.Determine the side of the VJR-A3-JW in which the external wires are to be routed and remove the plug from the knockout.
7.Apply a 1/2-in. (15-mm) NPS fitting to the chosen knockout. Ensure a water-tight fitting to maintain the IP Environmental Protection Rating for the unit.
8.Align the holes of the VJR-A3-JW with the mounting bracket. Note the alignment of the VJR-A3-JW relative to the bracket in Figure 6.13 below to ensure that the VJR-A3- JW knockouts are not covered by the bracket arms.
9.Thread the four (4) 3.97 mm I.D. by Ø1.78 mm O-rings (item 1, Figure 6.13) onto the four (4) M4 x 16 Phillips Pan Head Machine Screws (item 2).
F.01U.275.803 6.0 2012.11 | Installation Manual | Bosch Security Systems, Inc. |