54 en Installing a Recessed Mount | AutoDome Junior HD |
|
|
10.Ensure unit is centered.
NOTICE!
The recessed mounting bracket is provided with an additional safety tether point. To prevent injury, attach a safety wire from a secure anchor point above the ceiling to this tether point.
11.Align trim ring so the four alignment posts (item 1, below) align with the recesses in the camera housing (item 2) and so the two safety screws align with the off center holes (item 3) on the locking clamps.
Note: The two (2) sets of raised
Figure 6.9 Align Trim Ring
1Alignment Tabs (four)
2Align tabs to the recessed areas on the housing
3 Align safety locking screws to these connections
4
12.Snap trim ring into place. Ensure snaps are secure by attempting to lightly turn unit. Note: Unit should not turn.
13.Use a
F.01U.275.803 6.0 2012.11 | Installation Manual | Bosch Security Systems, Inc. |