92 en Using the IP Interface | AutoDome Junior HD |
|
|
1AutoDome Junior HD
2 IP Connection
3 Network Switch
4 Computer
NOTICE!
You can also use the Bosch Configuration Manager utility to configure the network settings for an AutoDome Junior IP or HD camera. Go to www.boschsecurity.com to download the Configuration Manager software and Operating Manual.
11.4Configuring the AutoDome Junior HD Camera
To operate the camera in your network you must assign it a valid network IP address. The default IP address is 192.168.0.1, but you may have to change this address if it conflicts with another device on your network. Refer to Section 12.3 Basic Mode: Network, page 111 for more information.
To properly configure the camera for your network, you need the following information:
–Unit IP address: An identifier for the camera on a TCP/IP network. For example, 140.10.2.110 is a valid syntax for an IP address.
–Subnet mask: A mask used to determine what subnet an IP address belongs to.
–Gateway IP address: A node on a network that serves as an entrance to another network.
–Port: An endpoint to a logical connection in TCP/IP and UDP networks. The port number identifies the use of the port for use through a firewall connection.
NOTICE!
Ensure that the network parameters of your cameras are available before you begin configuration.
F.01U.275.803 6.0 2012.11 | Installation Manual | Bosch Security Systems, Inc. |