Bosch Appliances VJR SERIES installation manual Commissioning the AutoDome Junior Fixed Camera

AutoDome Junior HD Using the IP Interface en 103

11.6Commissioning the AutoDome Junior Fixed Camera

The remote commissioning feature simplifies installation by allowing operators to position and zoom the camera via a remote head-end unit.

This section provides instructions for setting the position and the zoom level for an AutoDome Junior HD Fixed camera (VJR- F801 Series).

Using the Built-in Web Server:

1.Launch Microsoft Internet Explorer and navigate to the IP Address for the AutoDome Junior HD Fixed camera.

The Web browser opens the Livepage.

2.Type the password for the Service level user.

3.Click the SETTINGS link in the upper section of the window.

The Web browser opens a new page with the configuration menu.

4.Click the Advanced Link; then click the Camera link, located in the left pane of the Settings window.

5.Click the Installer Menu, located under the Camera link.

6.Click the Open button to the right of View Control to open the View Control window.

Note: The View Control window is disabled 15 minutes after you open the window. If the View Control window is disabled, you must close the window then re-open to resume setting the camera position and zoom level.

7.Use the View Control arrow keys and the zoom keys to establish the desired view.

Note: The AutoDome Junior HD fixed camera pans, tilts, and zooms at a much slower rate compared to a Pan/Tilt/ Zoom dome camera.

8.Close the View Control window to set the camera’s position and the zoom level.

9.Click the LIVEPAGE link, in the upper section of the window.

10.To reset the position and zoom level, repeat these steps.

Bosch Security Systems, Inc. Installation Manual F.01U.275.803 6.0 2012.11