Miller Electric XMS 4000 manual 100 h. std

Page 11

	1	2	3
			100 h. std.
4	=		5
	=
6			7
			7
			(B) 050024004
			207 290

1Warning! Watch Out! There are possible hazards as shown by the symbols.

2Disconnect input plug or power before working on machine.

3Wear approved safety glasses with side shields while working on the unit.

4Plugged filter or hoses can cause overheating to the power source and torch.

5Every 100 hours, check and clean filter and check condition of hoses.

6Read Owner’s Manual.

7Use coolant suggested by manufacturer.

	1	1 Warning! Watch Out! There
		1 Warning! Watch Out! There
		are possible hazards as
		shown by the symbols.
		2 Falling unit can cause injury.
		Do not move or operate unit
		where it could tip.
		3 Cylinders can expolde if
		damaged. Protect
		compressed gas cylinders
		from excessive heat,
		mechanical shock, slag, open
		flames, sparks, and arcs.
2		3
1		1 Warning! Watch Out! There
		are possible hazards as
		shown by the symbols.
		2 Moving parts can cause injury.
2		Keep away from moving parts
		such as fans.
		S-176 106

OM-224 043 Page 7

Image 11

Contents Xmsr From Miller to You Table of Contents Declaration of Conformity for European Community CE Products Arc Welding Hazards Symbol UsageMarks a special safety message Magnetic Fields can affect pacemakers ARC Rays can burn eyes and skinFire or Explosion hazard California Proposition 65 WarningsAbout Pacemakers Principal Safety StandardsEMF Information Manufacturer’s Warning Label Definitions − Definitions60 s 100 h. std I1eff Manufacturer’s Rating Labels Symbols And DefinitionsI1max Duty Cycle And Overheating − InstallationSpecifications Volt-Ampere Curves Remove wire spool Turntable ScrewLocation Dimensions and WeightMovement Do not move or operate unit where it could tip Selecting a Location120 m Weld Output Terminals And Selecting Cable SizesRemote 7 Receptacle Information TIG And Stick Only ARC Welding can cause Electromagnetic InterferenceFilling Coolant Tank Circuit Breakers= GND/PE Electrical Service GuideConnecting Input Power 50/60 Hz Three PhaseFront Panel Controls − OperationWelding Process Selection Switching On the Unit and Recalling Factory ParametersBe aware that the wire type selection is Gas Selection in Synergic MIG or Synergic Pulsed MIG Welding Trigger Mode Selection TIG and Stick OnlySetting Menu Type TIG and Stick only Setup Push Button And Advanced ProgrammingSelecting Manual MIG Welding During SettingSetting Cooler Status Preparing Unit For MIG WeldingDuring Synergic MIG Welding Setting Cooler Status see SectionSelecting Synergic MIG Welding Selecting Synergic Pulsed MIG Welding Preparing Unit For TIG Welding Setting Initial And Final Amperage only in Menu FullSetting Postflow only in Menu Full Setting Cooler Status only in Menu FullPreparing Unit For Stick Welding TIG Lift-Arc WeldingMonths − Maintenance & TroubleshootingHelp Displays Do not remove case when blowing out inside of unitBlowing Out Inside Of Unit Is displayed TroubleshootingSoftware problems OM-224 043 − Electrical Diagram Unit Outer Assembly − Parts ListDia Part Description Quantity Mkgs Unit Main Assembly CR5,6,R1 Page Effective January 1 ITW Welding Products Italy S.r.l. Via Privata Iseo, 6/E Owner’s Record

100 h. std.

(B) 050024004