Do not use tool if switch does not turn it
"ON" or "OFF". Any tool that cannot be
controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments,
changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally. Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.
Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with sharp cutting edges are less likely to bind and are easier to control. Any alteration or modification is a
misuse and may result in a dangerous condition.
Check for misaUgnment or binding of
moving parts, breakage of parts, and any other condition that may affect the tools operation. If damaged, have the tool serviced before using. Many accidents are
Accessories must be rated for at least
the speed recommended on the tool warning label. Wheels and other
accessories running over rated speed can fly apart and cause injury.
Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live"
and shock the operator. If cutting into existing walls or other blind areas where
electrical wiring may exist is unavoidable, disconnect all fuses or circuit breakers
feeding this worksite.
The following warning is intended for flex
shaft tools and accessories: Do not operate the flexible shaft with a sharp bend. Over bending the shaft can generate excessive heat on the jacket or hand piece. The recommended minimum is 6" radius.
Always disconnect the power cord from the power source before making any
adjustments or attaching any
accessories. You may unexpectedly cause the tool to start leading to serious persohal injury.
caused by poorly maintained tools. Develop a periodic maintenance schedule for your tool.
Use only accessories that are
recommended by the manufacturer for your model. Accessories that may be
suitable for one tool, may become hazardous when used on another tool.
Service
Tool service must be performed only by
qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. For example: internal wires may be misplaced
or pinched, safety guard return springs may be improperly mounted.
When servicing a tool, use only identical
replacement parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance Instructions may create a risk of electric shock or injury. Certain cleaning agents such as gasoline, carbon tetrachloride, ammonia, etc. may damage plastic parts.
Be aware of the switch location, when placing the tool down or when picking the tool up. You may accidentally activate the switch.
The following warning is intended for flex shaft tools and accessories: Always hold the hand piece firmly in your hands during the
Always hold the tool with two hands during
Always wear safety goggles and dust mask. Use only in well ventilated area. Using personal safety devices and working in safe environment reduces risk of injury.
After changing the bits or making any
adjustments, make sure the collet nut and any other adjustment devices are
securely tightened. Loose adjustment device can unexpectedly shift, causing loss of control, loose rotating components will be violently thrown.
Do not reach in the area of the spinning bit. The proximity of the spinning bit to your hand may not always be obvious.