TABLE OF CONTENTS
IMPORTANT SAFETY INSTRUCTIONS | 2 |
SAFETY GUIDELINES - DEFINITIONS | 3 |
GENERAL SAFETY RULES | 3 |
POWER CONNECTIONS | 5 |
MOTOR SPECIFICATIONS | 5 |
GROUNDING INSTRUCTIONS | 5 |
EXTENSION CORDS | 6 |
FEATURES AND COMPONENTS | 6 |
FUNCTIONAL DESCRIPTION | 7 |
PRODUCT SPECIFICATIONS | 7 |
UNPACKING | 7 |
ASSEMBLY | 8 |
Install Brake Lever Assembly | 8 |
Secure Tool to Supporting Surface | 8 |
Connect to Dust Hose to Dust Collector System | 8 |
OPERATION | 9 |
Starting and Stopping | 9 |
Removing the Safety Key to Lock the Sander | 9 |
Using the Manual Disc Brake | 9 |
Angled and End Sanding Using The Miter Gauge | 10 |
Bevel Sanding Using the Table Tilt | 10 |
ADJUSTMENTS | 11 |
Adjust Miter Gauge Slot Alignment | 11 |
Squaring the Table to the Sanding Disc | 11 |
RECOMMENDED MAINTENANCE | 12 |
Lubrication | 12 |
Routine Inspection | 12 |
Replacing Sanding Disc | 12 |
ACCESSORIES | 12 |
WARRANTY | 13 |
REPLACEMENT PARTS | 13 |
SERVICE AND REPAIRS | 13 |
FRANÇAIS | 14 |
ESPAÑOL | 27 |
IMPORTANT SAFETY INSTRUCTIONS
READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS EQUIPMENT. Failure to follow all instructions listed below, may result in electric shock, fire, and/or
serious personal injury or property damage.
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, there are certain hazards involved with the operation of the product. Using the machine with respect and caution will considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or ignored, personal injury to the operator may result. Safety equipment such as
guards, push sticks,
This machine was designed for certain applications only. DELTA® Power Equipment Corporation strongly recommends that this machine not be modified and/or used for any application other than that for which it was designed. If you have any questions relative to a particular application, DO NOT use the machine until you
have first contacted DELTA® to determine if it can or should be performed on the product.
If you have any questions relative to its application DO NOT use the product until you have written DELTA® Power Equipment Corporation and we have advised you. Contact us online at www.DeltaMachinery.com or by mail at Technical Service Manager, DELTA® Power Equipment Corporation, 99 Roush Street, Anderson, South Carolina 29625.
Information regarding the safe and proper operation of this tool is available from the following sources:
•Power Tool Institute, 1300 Sumner Avenue, Cleveland, OH
•National Safety Council, 1121 Spring Lake Drive, Itasca,
•American National Standards Institute, 25 West 43rd Street, 4 floor, New York, NY 10036 www.ansi.org - ANSI 01.1 Safety Requirements for Woodworking Machines
•U.S. Department of Labor regulations www.osha.gov
2