ASSEMBLY
INSTALL BRAKE LEVER
ASSEMBLY
•Refer to Figure 2 and remove the 2 hex screws (A) from the disc housing using the 2.5mm Allen wrench
supplied.
• Align the screw holes in the brake lever assembly (B) with the holes in the disc housing and secure using the hex screws removed in Step 1.
FIGURE 2
SECURE TOOL TO SUPPORTING SURFACE
Important: If during operation there is any tendency for the sander to tip over, slide or walk on the supporting surface, the sander must be secured to the supporting surface.
To secure the sander to the supporting surface, use screws or bolts and nuts through the four holes (A) as shown in Figure 3.
A
FIGURE 3
CONNECT DUST HOSE TO
DUST COLLECTOR SYSTEM
The 12" Disc Sander has an efficient, integral fan which provides excellent dust collection. It is recommended that the machine be attached to a dust collector using the 2 1/4” dust port (A) shown in Figure 4.
If a dust collector is not available, insert one end of the supplied dust hose (B) into the dust port and place the other end of the dust hose into a garbage can or other receptacle.
FIGURE 4
8