Schumacher INC-2405A owner manual Product Features, Control panel

Page 11

10.PRODUCT FEATURES

1

4

2

3

5

1.Charger Status LEDs (located on side of unit)

2.Battery Clamp Output Cord

3.3 Pin XLR 3-12C Output Cord

4.3/8” Dia. Ring Terminal Output Cord

5.AC Cord

11.mounting charger to a flat surface

Do not mount charger in a location with restricted air flow. The area where the charger is to be fastened must be dry, well ventilated and away from any combustible material and fumes.

11.1Turn off and disconnect charger.

11.2Place the back of the charger with mounting bracket against a secure, flat surface.

11.3Securely mount charger to a flat surface with a minimum of one and a half inches of clearance on each side.

12.control panel

12.1POWER ON (red) LED – The red POWER ON LED lights up when the charger is plugged in and receiving AC power.

6

Image 11
Contents Guide D’UTILISATION Page Table of Contents / Índice / Table DES Matières Bateria Cargando Conexiones AC Instrucciones DE Ensamblaje Page Important Safety Instructions Page Charger Location DC Connection PrecautionsPreparing to Charge Page Assembly instructions No assembly required Battery charging ac connectionsControl panel Product FeaturesCalculating charge time Operating instructionsExample Maintenance instructionsSpecific Gravity Percent of Charge Needed Storage instructions TroubleshootingLED GUIDE/PROBLEM Possible Cause Solution Connections Technical specificationsElectrical Battery Clamp Output Cord 38-99-002111 Replacement partsPage Instrucciones DE Seguridad Importantes Precauciones Personales Ubicación DEL Cargador PREPARación de la cargaPrecauciones DE LA Conexión CC Bateria Cargando Conexiones AC Siga Estos Pasos cuando la batería esté afuera del vehículoCaracterísticas del producto Instrucciones DE EnsamblajeColor del LED /Pauta Explicación Intermitente Montaje DEL Cargador Sobre UNA Superficie PlanaPanel DE Control DEL ‘CHARGING Status amarillo y verde El DEL ChargingEjemplo 14. Cálculo DE Tiempo DE CargaGravedad Específica Porcentaje de Carga Instrucciones DE Almacenaje Instrucciones DE MantenimientoAntes DE Devolver EL Cargador Para Reparación Solución DE ProblemasConexiones Especificaciones TécnicasEléctricas MecánicasPage Page La clientèle au Page Préparation Pour LE Chargement Emplacement DU ChargeurPrécautions SUR LA Connexion C.C Chargement D’UNE Batterie Raccordements C.A Directives DE Montage Aucun montage n’est nécessaire Panneau DE Contrôle Installer LE Chargeur SUR UNE Surface PlaneCaractéristiques Consignes D’UTILISATION Exemple Calcul DU Temps DE ChargementLe densimètre ou la méthode électronique Tableau DE Dépannage Consignes D’ENTRETIENDirectives D’ENTREPOSAGE Données mécaniques Avant DE L’ENVOYER Pour Réparation19. Spécifications Techniques Données d’alimentationConnexions 20. Pièces DE Remplacement