Hitachi CR 14DSL Important Safety Instructions for Battery Charger, Read ALL Instructions

Page 6
= 10 amperes

English

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGER

WARNING:

Death or serious bodily injury could result from improper or unsafe use of battery chargers. To avoid these risks, follow these basic safety instructions:

READ ALL INSTRUCTIONS

1.This manual contains important safety and operating instructioYGSLns for battery charger Model UC18YRSL and UC18YGSL.

2.Before using battery charger, read all instructions and cautionary markings on (1) battery charger,

(2) battery, and (3) product using battery.

3.To reduce risk of injury, charge HITACHI rechargeable battery type BSL14 and BSL18 series. Other type of batteries may burst causing personal injury and damage.

4.Do not expose battery charger to rain or snow.

5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in

arisk of fire, electric shock, or injury to persons.

6.To reduce risk of damage to electric plug and cord, pull by plug when disconnecting battery charger.

7.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

8.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used make sure:

a.That blades of extension cord are the same number, size, and shape as those of plug on battery charger:

b.That extension cord is properly wired and in good electrical condition; and

c.That wire size is large enough for AC ampere rating of battery charger as specified in Table 1.

Table 1

RECOMMENDED MINIMUM AWG SIZE FOR

EXTENSION CORDS FOR BATTERY CHARGERS

AC Input Rating Amperes*

 

AWG Size of Cord

 

Equal to or

but less

Length of Cord, Feet (Meter)

 

greater than

than

25 (7.5)

50 (15)

100 (30)

150 (45)

0

2

18

18

18

16

2

3

18

18

16

14

3

4

18

18

16

14

*If the input rating of a battery charger is given in watts rather than in amperes, the corresponding ampere rating is to be determined by dividing the wattage rating by the voltage rating–for example:

1,250 watts

125volts

9.Do not operate battery charger with damaged cord or plug-replace them immediately.

10.Do not operate battery charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble battery charger; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.

12.To reduce risk of electric shock, unplug charger from receptacle before attempting any maintenance or cleaning. Removing the battery will not reduce this risk.

IMPORTANT SAFETY INSTRUCTIONS FOR USE OF THE BATTERY AND BATTERY CHARGER

You must charge the battery before you can use the power tool. Before using the model UC18YRSL or UC18YGSL battery charger, be sure to read all instructions and cautionary statements on it, the battery and in this manual.

CAUTION:

USE ONLY HITACHI BATTERY TYPE BSL14 AND BSL18 SERIES. OTHER TYPES OF BATTERIES MAY BURST AND CAUSE INJURY!

Follow these instructions to avoid the risk of injury:

WARNING:

Improper use of the battery or battery charger can lead to serious injury. To avoid these injuries:

6

Image 6
Contents Modèle CR 14DSL CR 18DSL Cordless Reciprocating SawContents Meanings of Signal Words SafetyImportant Safety Information General Power Tool Safety WarningsMany accidents are caused by poorly maintained power tools Power tool use and carePower tools are dangerous in the hands of untrained users Use of dust collection can reduce dust-related hazardsSpecific Safety Rules and Symbols Read ALL Instructions Important Safety Instructions for Battery ChargerBattery, and 3 product using battery AC Input Rating Amperes AWG Size of CordNever connect two battery chargers together Savethese Instructions Functional Description Latch BatteryVentilation holes Terminals Battery cover Latch Name of PartsSpecifications Applications Assembly and OperationRemoval and Installation Method of Battery Charging MethodUC18YRSL Temperatures at whichCharging UC18YGSLBefore USE OperationWhen the Blade is Broken Maintenance and Inspection of SAW Blade MountBlade holder Lever Blade hole Adjusting the baseHOW to USE the Cordless Reciprocating SAW Lever Rubber capCutting lumber Trigger switchCutting metallic materials Fasten a workpiece firmly before operation. FigIndicator lamp About Remaining Battery IndicatorRemaining battery Indicator switch Battery Plunge cuttingInspecting the blade Maintenance and InspectionLastly, install the brush cap Nail of carbon brush Wear limitDisposal of the exhausted battery Service parts listModifications Optional ACCESSORIES.....sold separately AccessoriesStandard Accessories Battery BSL1430 Code NoSaw Blades Sécurité Informations Importantes DE SécuritéSignification DES Mots D’AVERTISSEMENT Si loutil est endommagé, le faire réparer avant utilisation Sécurité personnelleUtilisation et entretien dun outil électrique Maintenir les outils coupants aiguisés et propresRegles DE Sécurité Spécifiques ET Symboles AvertissementVient par minute Lire Tout CE Mode DemploiNe pas essuyer les parties en plastique avec du solvant TableauPrecaution Précautions Relatives a LA Batterie AU Lithium IONConserver CES Instructions Le liquide peut provoquer une irritation de la peauNOM DES Parties Description FonctionnelleRemarque Couvercle avant InterrupteurScie alternative sans fil Modèle Plaque signalétiqueRail guide MoteurUtilisations Méthode DE Retrait ET D’INSTALLATION DE LA BatterieAssemblage ET Fonctionnement Méthode DE Recharge RemarqueRecharge Indication de la lampe témoinTableau 3 UC18YGSL Avant L’UTILISATION Pour UC18YRSLPour UC18YGSL UtilisationManchon de support Démontage de la lameSI LA Lame EST Cassee Entretien ET Inspection DE LA Monture DE Lame Comment Utiliser LA Scie Alternative À Batterie Precaution  Appuyer le socle fermement contre la pièceFixer solidement la pièce avant de procéder. Fig Coupe de boisAttaque en plein bois Est Commutateur de TémoinLumineux de Résiduelle Puissance Batterie Tableau SuffisanteEntretien ET Inspection PrécautionVérifier s’il y a de la poussière Mise au rebut d’une batterie uséeListe des pièces de rechange Vendus séparément AccessoiresAccessoires Standard Batterie BSL1430 N de codeLames HCS Acier AU Carbone RapideSignificado DE LAS Palabras DE Señalización SeguridadInformación Importante Sobre Seguridad Las zonas desordenadas o oscuras pueden provocar accidentesEl uso de un RCD reduce el riesgo de descarga eléctrica Seguridad personalMantenga las herramientas de corte afiladas y limpias Advertencia Normas Y Símbolos Específicos DE SeguridadLEA Todas LAS Instrucciones No exponga el cargador de baterías a la lluvia ni a la nieveVatios = 10 amperios Voltios TablaLongitud del cable, Pies metros Nunca conecte dos cargadores de baterías juntosNo utilice una batería que pudiera estar dañada o deformada Póngalas a Disposición DE Otros UsuariosAdvertencia DE LA Batería DE Litio Podría producir irritación de la pielDescripción Funcional NotaNomenclatura Especificaciones Método DE Extracción E Instalación DE LA Batería Montaje Y OperaciónAplicaciones Método DE Carga NotaIndicaciones de la lámpara piloto CargaTabla 3 UC18YGSL Mal funcionamentoAntes DE LA Utilización OperaciónPalanca Hoja Instalada. Al tirar de la hoja sabrá si estáHoja Ranura del émbolo Desmontaje de la hojaOrificio de la hoja Hoja Cómo ajustar la base Otra hojaPalanca Tapa de goma Tornillo deComo Usar LA Sierra Sable a Batería Precaución  No desmonte la cubierta delantera consulte la Fig Presione la base firmemente contra la pieza de trabajo Corte por penetración Corte de líneas curvadasIndicador La potencia restante de la batería es suficiente IndicadorRestante Luminoso de Batería restante Tabla Interruptor de Indicador de bateríaMantenimiento del motor Mantenimiento E InspecciónInspeccionar la hoja Limite de usoModificaciones Accesorios OPCIONALES.....de venta por separado AccesoriosAccesorios Estándar Batería BSL1430 Núm de códigoHojas Clavada’TY 12M4× SCREWHD. Flatlock Seal Export Blvd. Unit B Mississauga on L5T 2A4