Siemens FC330A manual Paper replacement with logging printer B2Q191, Switch off the printer

Paper replacement with logging printer B2Q191

Switch off the printer

Before changing the printer paper disable the printer by the control panel menu (+ page 44).

G

		F	H
B	A	E
		D
		C
		J

B2Q101

I	II	III		V
			IV

Change of printer paper

1.Remove the screws on the right−hand side or open the hinged cover with the key.

2.Swing out the printer unit.

3.Undo the clamp H and remove the used paper roll (see picture IV).

4.Lift the paper flap A and attach the a new paper roll on the spindle B. Assure that the moving direction of the paper roll is clockwise (see picture I).

5.Press the leading edge of the paper tape lightly against the flap A and feed it through slot C into the printer (see picture II).

6.Press down the release lever D and shove the paper tape through the printer (see picture III).

7.Relinquish release lever D. The paper can now be transported by means of the knurled wheel E (see picture III).

8.Feed the paper tape through slot F.

9.Thread the leading edge of the paper around the take−up roller G and fix it with clamp H (see pictures IV and V).

10.Press the winding up key J (see picture III) to wind up the paper and to reset of the “End of paper” fault.

Enable the printer

After changing the printer paper, enable the printer by the control panel menu (+ page 44).

Spare paper rolls

Following types of paper rolls are available for the printer:

npart no. 279 977 (4 pieces)

nJUJU TP 50KS−A

nHOSHU PS 65 B1

nMITSUBISHI F−200 U7X

Print intensity

If the print intensity is too low, call the SIEMENS service organization.

45

Fire & Security Products	e1973c-13
Siemens Building Technologies Group	02.2004