Assembling the grinding unit: (fig. 1)
•Introduce the screw (6) (long shaft first) into the grinding unit (5).
•Position the blade (7) on the short shaft of the screw setting the cutting edges facing outside on the grid side.
•Place the selected grid (8) on the blade and slot the two lugs into the two slots of the unit.
•Screw in the nut (9) fully without sticking.
•Check assembly. The axis must neither be loose nor stick in rotation. If loose or stuck, repeat assembly operations.
Caution:
•Do not run the appliance empty (without grinding meat).
•You are advised to apply cooking oil to the grid after cleaning.
Never push with your fingers.
IMPORTANT: Wait for the appliance to come to a complete stop before pressing switches.
Some recipes
GB require high power (about 800 W). For such recipes, do not operate for more than 30 seconds at a time.
Fitting the grinding unit on the appliance:
Make sure the appliance is switched off at the mains or unplugged.
•Tilt the grinding unit to the right. (fig. 2).
•Fully engage the grinding unit into the motor unit and turn to the left, then engage the tray.
•Close the door (14).
•Connect the appliance.
•Prepare the ingredients to be chopped, first removing bones, cartilage, sinews and rind.
•Cut the meat into pieces (about 2cm x 2cm) and place them on the tray.
•Never attempt to chop bits of bone, cartilage and rind.
•Select the grid:
-small holes: dia. 3mm: very tender meat
-medium holes: dia. 4.7mm: beef, pork, lamb, poultry, etc.
-large holes: dia. 7.5mm: sausages, fatty meats, etc.
•For maximum efficiency, cut pieces to a smaller size than the funnel.
•Put a bowl under the grinding unit.
•Set the switch on the rear of the appliance to “I” (fig. 4).
•Introduce the pieces of meat into the grinding unit and push in using the pusher (2) if necessary.
What to do if clogging occurs:
•Set the switch to the “O” position to stop the grinding unit.
•Open the accessory storage door.
•Press the “reverse” switch for a few seconds to release the food. (fig. 5) ;
•Then close the door and start again by pressing the main switch to complete grinding.
96