HP Performance Optimized Data Center (POD) 240a manual Parts and part number identification

Item	Component	Description
1	Canopy	The canopy has two 6.10 m (20 ft) parts that are installed on top of the HP
		POD 240e NA.
2	Adiabatic units and	Each of the four cradles contain three Adiabatic units.
	cradles
3	AHU service area end	The HP POD 240e offers AHU service access in these two locations.
	walls
4	IT section A (primary	The IT section A (primary structure) contains the ECS. Conditioned air passes
	structure)	through the IT section A and IT section B structures to force cool air through the
		IT equipment.
5	Hot aisle	The hot aisle structure is a separate space where hot exhaust air from the
		servers can be expelled out of the structure or recirculated. The HP POD 240e
		isolates the IT sections from the hot aisle for efficiency.
6	IT section B (secondary	The IT section B (secondary structure) is similar to the IT section A (primary
	structure)	structure), but IT section B does not contain the ECS.

IMPORTANT: You must consult with the AHJ to determine the egress requirements for the hot-aisle service area that you must provide. Requirements might include landings and stairs to be installed at both ends of the hot aisle service area for emergency egress.

Parts and part number identification

Review all of the contents to identify the following for each component:

Regulatory model number

The following figure shows the location of the regulatory model number and the POD solution serial numbers on the inside of each IT section, adjacent to the bump out.

Interior side view shown

CSC Safety Approval placard

Component identification 9