HP C4344 manual To set up the product with voice mail

Page 18

Chapter 2

To set up the product with voice mail

1.Using the phone cord supplied in the box with the product, connect one end to your telephone wall jack, then connect the other end to the port labeled 1-LINE on the back of the product.

NOTE: If you do not use the supplied cord to connect from the telephone wall jack to the product, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office.

2.Turn off the Auto Answer setting.

3.Run a fax test.

You must be available to respond in person to incoming fax calls, or the product cannot receive faxes.

Case G: Fax line shared with computer dial-up modem (no voice calls received)

If you have a fax line on which you receive no voice calls, and you also have a computer dial-up modem connected on this line, set up the HP All-in-One as described in this section.

Since your computer dial-up modem shares the phone line with the HP All-in-One, you will not be able to use both your modem and the HP All-in-One simultaneously. For example, you cannot use the HP All-in-One for faxing if you are using your computer dial- up modem to send an e-mail or access the Internet.

Figure 2-6 Back view of the HP All-in-One

Fax setup

1Telephone wall jack

2Use the phone cord supplied in the box with the HP All-in-One to connect to the "1-LINE" port

3Computer with modem

To set up the product with a computer dial-up modem

1.Remove the white plug from the port labeled 2-EXT on the back of the product.

2.Find the phone cord that connects from the back of your computer (your computer dial-up modem) to a telephone wall jack. Disconnect the cord from the telephone wall jack and plug it into the port labeled 2-EXT on the back of the product.

16 Fax setup

Image 18

Contents Basics Guide Hewlett-Packard Company notices Contents HP All-in-One overview HP All-in-One at a glanceControl panel buttons HP All-in-One overviewFind more information Setup Guide Onscreen HelpSet up the HP All-in-One for faxing Countries/regions with a parallel-type phone systemChoose the correct fax setup for your home or office Select your fax setup case Not applicable Case a Separate fax line no voice calls received Back view of the HP All-in-OneCase B Set up the HP All-in-One with DSL To set up the product with a separate fax lineTo set up the product with DSL Case D Fax with a distinctive ring service on the same line To set up the product with a distinctive ring serviceTo set up the product with a shared voice/fax line Case E Shared voice/fax lineCase F Shared voice/fax line with voice mail Do one of the following, depending on your phone systemTo set up the product with voice mail To set up the product with a computer dial-up modemCase H Shared voice/fax line with computer dial-up modem Fax setup Case I Shared voice/fax line with answering machine Fax setup Back view of the HP All-in-One Fax setup 10 Back view of the HP All-in-One To set the Auto Answer setting Change settings on the HP All-in-One to receive faxesChoose the recommended answer setting for your setup Change the answer ring pattern for distinctive ringingSet the fax header Test your fax setupTo test your fax setup from the control panel To set a fax header from the control panelFax setup Load originals and load paper To load an original on the glassTo load small-size photo paper in the input tray Avoid paper jams Print 10 x 15 cm 4 x 6 inch photosTo print one or more 10 x 15 cm 4 x 6 inch photos Scan an image XD-Picture CardTo scan to a computer Make a copySend a basic fax To make a copy from the control panelIf you have another page to fax Receive a faxTo send a basic fax from the control panel If you do not have another page to faxReplace the print cartridges To receive a fax manuallyTo replace the print cartridges Replace the print cartridges Close the print cartridge door Clean the lid backing Clean the HP All-in-OneClean the glass To clean the glassChapter Uninstall and reinstall the software Troubleshooting common setup issuesTo uninstall and reinstall the software Solution Setup troubleshootingSolution 2 Reset the product Product will not turn onSolution 3 Press the On button more slowly Solution 4 Contact HP to replace the power supplySolution 5 Contact HP support for service After setting up the product, it does not print Fax setup troubleshooting Product is having problems sending and receiving faxesSolution 2 Turn on the product Troubleshooting and support Solution 5 Try removing the splitter Solution 6 Make sure the telephone wall jack works properlySolution 7 Check the phone line for noise Troubleshooting and support Solution 13 Check for and resolve any error messages Solution 14 Lower the fax speedSolution 2 Check the Auto Answer setting Solution 3 Set the product to answer faxes manuallyProduct cannot receive faxes, but can send faxes Solution Troubleshooting and support Solution 10 Clear the memory of the product Solution 11 Check for error messages on the displayFax tones are recorded on my answering machine Solution 2 Set up the product to answer faxes automatically Solution 4 Check the receiving fax machine for problems Solution 2 Check the fax numberSolution 3 Dial the fax number more slowly Product cannot send faxes, but can receive faxesFax Hardware Test failed Fax Connected to Active Telephone Wall Jack test failedPhone Cord Connected to Correct Port on Fax test failed To plug the phone cord into the correct portUsing Correct Type of Phone Cord with Fax test failed Fax Line Condition test failed Dial Tone Detection test failedClear paper jams To clear a paper jam from the rear doorPrint cartridge troubleshooting If you have a problem, follow these stepsSupport process Product specifications System requirementsRegulatory notices Warranty HP product Duration of limited warranty$UJHQWLQD

Related manuals

Manual 317 pages 59.26 Kb