HP C4344 Set up the HP All-in-One for faxing, Countries/regions with a parallel-type phone system

Page 8

2 Fax setup

After completing all the steps in the Setup Guide, use the instructions in this section to complete your fax setup. Please keep your Setup Guide for later use.

In this section, you will learn how to set up the HP All-in-One so that faxing works successfully with equipment and services you might already have on the same phone line as the HP All-in-One.

TIP: You can also use the Fax Setup Wizard (Windows) or Fax Setup Utility (Mac) to help you quickly set up some important fax settings such as the answer mode and fax header information. You can access the Fax Setup Wizard (Windows) or Fax Setup Utility (Mac) through the software you installed with the HP All-in-One. After you run the Fax Setup Wizard (Windows) or Fax Setup Utility (Mac), follow the procedures in this section to complete your fax setup.

Fax setup

Set up the HP All-in-One for faxing

Before you begin setting up the HP All-in-One for faxing, determine which kind of phone system your country/region uses. The instructions for setting up the HP All-in-One for faxing differ depending on whether you have a serial- or parallel-type phone system.

•If you do not see your country/region listed in the table below, you probably have a serial-type phone system. In a serial-type phone system, the connector type on your shared telephone equipment (modems, phones, and answering machines) does not allow a physical connection to the "2-EXT" port on the HP All-in-One. Instead, all equipment must be connected at the telephone wall jack.

NOTE: In some countries/regions that use serial-type phone systems, the phone cord that came with the HP All-in-One might have an additional wall plug attached to it. This enables you to connect other telecom devices to the wall jack where you plug in the HP All-in-One.

•If your country/region is listed in the table below, you probably have a parallel-type telephone system. In a parallel-type phone system, you are able to connect shared telephone equipment to the phone line by using the "2-EXT" port on the back of the HP All-in-One.

NOTE: If you have a parallel-type phone system, HP recommends you use the 2-wire phone cord supplied with the HP All-in-One to connect the HP All-in-One to the telephone wall jack.

Table 2-1 Countries/regions with a parallel-type phone system

Argentina

 

Australia

 

Brazil

 

 

 

 

 

Canada

 

Chile

 

China

 

 

 

 

 

Colombia

 

Greece

 

India

 

 

 

 

 

Indonesia

 

Ireland

 

Japan

 

 

 

 

 

6 Fax setup

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Basics Guide Hewlett-Packard Company notices Contents HP All-in-One overview HP All-in-One at a glanceControl panel buttons HP All-in-One overviewFind more information Setup Guide Onscreen HelpSet up the HP All-in-One for faxing Countries/regions with a parallel-type phone systemChoose the correct fax setup for your home or office Select your fax setup case Not applicable Case a Separate fax line no voice calls received Back view of the HP All-in-OneCase B Set up the HP All-in-One with DSL To set up the product with a separate fax lineTo set up the product with DSL Case D Fax with a distinctive ring service on the same line To set up the product with a distinctive ring serviceTo set up the product with a shared voice/fax line Case E Shared voice/fax lineCase F Shared voice/fax line with voice mail Do one of the following, depending on your phone systemTo set up the product with voice mail To set up the product with a computer dial-up modemCase H Shared voice/fax line with computer dial-up modem Fax setup Case I Shared voice/fax line with answering machine Fax setup Back view of the HP All-in-One Fax setup 10 Back view of the HP All-in-One Change settings on the HP All-in-One to receive faxes Choose the recommended answer setting for your setupTo set the Auto Answer setting Change the answer ring pattern for distinctive ringingTest your fax setup To test your fax setup from the control panelSet the fax header To set a fax header from the control panelFax setup To load small-size photo paper in the input tray Load originals and load paperTo load an original on the glass To print one or more 10 x 15 cm 4 x 6 inch photos Avoid paper jamsPrint 10 x 15 cm 4 x 6 inch photos Scan an image XD-Picture CardMake a copy Send a basic faxTo scan to a computer To make a copy from the control panelReceive a fax To send a basic fax from the control panelIf you have another page to fax If you do not have another page to faxTo replace the print cartridges Replace the print cartridgesTo receive a fax manually Replace the print cartridges Close the print cartridge door Clean the HP All-in-One Clean the glassClean the lid backing To clean the glassChapter To uninstall and reinstall the software Uninstall and reinstall the softwareTroubleshooting common setup issues Setup troubleshooting Solution 2 Reset the productSolution Product will not turn onSolution 5 Contact HP support for service Solution 3 Press the On button more slowlySolution 4 Contact HP to replace the power supply After setting up the product, it does not print Solution 2 Turn on the product Fax setup troubleshootingProduct is having problems sending and receiving faxes Troubleshooting and support Solution 7 Check the phone line for noise Solution 5 Try removing the splitterSolution 6 Make sure the telephone wall jack works properly Troubleshooting and support Solution 13 Check for and resolve any error messages Solution 14 Lower the fax speedProduct cannot receive faxes, but can send faxes Solution 2 Check the Auto Answer settingSolution 3 Set the product to answer faxes manually Solution Troubleshooting and support Solution 10 Clear the memory of the product Solution 11 Check for error messages on the displayFax tones are recorded on my answering machine Solution 2 Set up the product to answer faxes automatically Solution 2 Check the fax number Solution 3 Dial the fax number more slowlySolution 4 Check the receiving fax machine for problems Product cannot send faxes, but can receive faxesFax Hardware Test failed Fax Connected to Active Telephone Wall Jack test failedPhone Cord Connected to Correct Port on Fax test failed To plug the phone cord into the correct portUsing Correct Type of Phone Cord with Fax test failed Fax Line Condition test failed Dial Tone Detection test failedClear paper jams To clear a paper jam from the rear doorSupport process Print cartridge troubleshootingIf you have a problem, follow these steps Regulatory notices Product specificationsSystem requirements Warranty HP product Duration of limited warranty$UJHQWLQD
Related manuals
Manual 317 pages 59.26 Kb
Top Page Image Contents