HP C4344 manual Avoid paper jams, Print 10 x 15 cm 4 x 6 inch photos

Page 30

Chapter 3

2.Insert the stack of photo paper into the far-right side of the input tray with the short edge forward and the print side down. Slide the stack of photo paper forward until it stops.

If the photo paper you are using has perforated tabs, load the photo paper so that the tabs are closest to you.

3.Slide the paper-width guide inward until it stops at the edge of the paper.

Do not overload the input tray; make sure the stack of paper fits within the input tray and is no higher than the top of the paper-width guide.

Use the

HP All -in

-One features

Avoid paper jams

To help avoid paper jams, follow these guidelines.

Remove printed papers from the output tray frequently.

Prevent curled or wrinkled photo paper by storing all unused photo paper flat in a resealable bag.

Ensure that paper loaded in the input tray lays flat and the edges are not bent or torn.

Do not combine different paper types and paper sizes in the input tray; the entire stack of paper in the input tray must be the same size and type.

Adjust the paper-width guide in the input tray to fit snugly against all paper. Make sure the paper-width guide does not bend the paper in the input tray.

Do not overload the input tray; make sure the stack of paper fits within the input tray and is no higher than the top of the paper-width guide.

Do not force paper too far forward in the input tray.

Use paper types that are recommended for the product.

Print 10 x 15 cm (4 x 6 inch) photos

You can select specific photos on your memory card to print as 10 x 15 cm (4 x 6 inch) photos.

To print one or more 10 x 15 cm (4 x 6 inch) photos

1.Load 10 x 15 cm (4 x 6 inch) photo paper in the input tray.

2.Insert your memory card into the appropriate slot on the product.

28 Use the HP All-in-One features

Image 30
Contents Basics Guide Hewlett-Packard Company notices Contents HP All-in-One overview HP All-in-One at a glanceControl panel buttons HP All-in-One overviewFind more information Setup Guide Onscreen HelpSet up the HP All-in-One for faxing Countries/regions with a parallel-type phone systemChoose the correct fax setup for your home or office Select your fax setup case Not applicable Case a Separate fax line no voice calls received Back view of the HP All-in-OneCase B Set up the HP All-in-One with DSL To set up the product with a separate fax lineTo set up the product with DSL Case D Fax with a distinctive ring service on the same line To set up the product with a distinctive ring serviceTo set up the product with a shared voice/fax line Case E Shared voice/fax lineCase F Shared voice/fax line with voice mail Do one of the following, depending on your phone systemTo set up the product with voice mail To set up the product with a computer dial-up modemCase H Shared voice/fax line with computer dial-up modem Fax setup Case I Shared voice/fax line with answering machine Fax setup Back view of the HP All-in-One Fax setup 10 Back view of the HP All-in-One To set the Auto Answer setting Change settings on the HP All-in-One to receive faxesChoose the recommended answer setting for your setup Change the answer ring pattern for distinctive ringing Set the fax header Test your fax setup To test your fax setup from the control panel To set a fax header from the control panelFax setup Load originals and load paper To load an original on the glassTo load small-size photo paper in the input tray Avoid paper jams Print 10 x 15 cm 4 x 6 inch photosTo print one or more 10 x 15 cm 4 x 6 inch photos Scan an image XD-Picture CardTo scan to a computer Make a copySend a basic fax To make a copy from the control panelIf you have another page to fax Receive a faxTo send a basic fax from the control panel If you do not have another page to faxReplace the print cartridges To receive a fax manuallyTo replace the print cartridges Replace the print cartridges Close the print cartridge door Clean the lid backing Clean the HP All-in-OneClean the glass To clean the glassChapter Uninstall and reinstall the software Troubleshooting common setup issuesTo uninstall and reinstall the software Solution Setup troubleshootingSolution 2 Reset the product Product will not turn onSolution 3 Press the On button more slowly Solution 4 Contact HP to replace the power supplySolution 5 Contact HP support for service After setting up the product, it does not print Fax setup troubleshooting Product is having problems sending and receiving faxesSolution 2 Turn on the product Troubleshooting and support Solution 5 Try removing the splitter Solution 6 Make sure the telephone wall jack works properlySolution 7 Check the phone line for noise Troubleshooting and support Solution 13 Check for and resolve any error messages Solution 14 Lower the fax speedSolution 2 Check the Auto Answer setting Solution 3 Set the product to answer faxes manuallyProduct cannot receive faxes, but can send faxes Solution Troubleshooting and support Solution 10 Clear the memory of the product Solution 11 Check for error messages on the displayFax tones are recorded on my answering machine Solution 2 Set up the product to answer faxes automatically Solution 4 Check the receiving fax machine for problems Solution 2 Check the fax numberSolution 3 Dial the fax number more slowly Product cannot send faxes, but can receive faxesFax Hardware Test failed Fax Connected to Active Telephone Wall Jack test failedPhone Cord Connected to Correct Port on Fax test failed To plug the phone cord into the correct portUsing Correct Type of Phone Cord with Fax test failed Fax Line Condition test failed Dial Tone Detection test failedClear paper jams To clear a paper jam from the rear doorPrint cartridge troubleshooting If you have a problem, follow these stepsSupport process Product specifications System requirementsRegulatory notices Warranty HP product Duration of limited warranty$UJHQWLQD
Related manuals
Manual 317 pages 59.26 Kb