Omega Vehicle Security FPU5-MT-110, FPU5-MT-220 manual Stopped vs. Running Display Modes

4Turning on the Power

3.Turn on the unit’s power. You are now in the STOPPED Display Mode (refer to Figure 4-1). The motor and the pump(s) are stopped. The display flashes, indicating that the pump motor is waiting for you to do something. The non- flashing, green LEDs indicate the tubing inlets (refer to Section 5.2), but fluid is not flowing.

	START
	STOP
STOPPED	RUNNING
DISPLAY
	DISPLAY
MODE
	MODE
	START
	STOP

Figure 4-1. STOPPED vs. RUNNING Display Modes

4.4 The RUNNING Display Mode

	START
	STOP
	Display
STOPPED	enters RUNNING Display Mode
Display Mode
	ACTION
	Pump(s) starts

Figure 4-2. RUNNING Display Mode

To enter the RUNNING Display Mode, do the following:

1.From the STOPPED Display Mode, press the START/STOP key. You are now in the RUNNING Display Mode. Refer to Figure 4-2. The pump motor starts. The attached pump(s) begin pumping fluid. The display is not flashing. The green LEDs flash and point to the tubing inlets.

2.Press the START/STOP key again. The pump motor stops. Fluid stops dispensing. You return to the STOPPED Display Mode.

4-2