Omega Vehicle Security FPU5-MT-110 Selecting the Tubing Inner Diameter, Left Pump Right Pump

5Operating the Pump Motor in the STOPPED Display Mode

INLET SELECT		RPM	TIME	INLET SELECT
	LEFT PUMP			RIGHT PUMP
INLET		FLOW	TOTAL	PRIME
SELECT		RATE	VOLUME
TEMP		TUBE ID	CALIBRATE	START
				STOP
MOTOR TURNING			MOTOR TURNING
COUNTER-CLOCKWISE			CLOCKWISE
		INLET		OUTLET
		OUTLET		INLET
Left Pump			Right Pump
	INLET SELECT	RPM	TIME	INLET SELECT
	LEFT PUMP			RIGHT PUMP
INLET		FLOW	TOTAL	PRIME
SELECT		RATE	VOLUME
TEMP		TUBE ID	CALIBRATE	START
				STOP
MOTOR TURNING			MOTOR TURNING
	CLOCKWISE		COUNTER-CLOCKWISE
		OUTLET		INLET
		INLET		OUTLET
Left Pump			Right Pump

Figure 5-1. Defining the Direction of Pumping

3.To change the direction of pumping, press the INLET SELECT key. The lit, green LEDs change positions. Fluid flows in the opposite direction.

4.To change back to the original direction of pumping, simply press the INLET SELECT key again.

5.3Selecting the Tubing Inner Diameter

The TUBE ID, and UP and DOWN ARROW keys allow you to select the inner diameter of the tubing.

NOTE

With the peristaltic pump motor, you can either select a tubing size from those shown in the display (using the TUBE ID key), or you can calibrate each piece of tubing you use (using the CALIBRATE key, as described in Section 5.5).

5-4