Omega Vehicle Security FPU5-MT-220, FPU5-MT-110 manual Flow Rate Mode

	Table 6-2		FLOW RATE MODE
KEY		DISPLAY	ACTION TAKEN
		SHOWS	AND PROCEDURE
			Pump motor’s power
ON/OFF Switch		XXX mL/min
		or	NOTE: if you turn off the pump motor’s power, the pump stops
		XXX L/min	running.
			To continue pumping, turn on the unit’s power. The display
			returns to the STOPPED Display Mode and shows the current
			FLOW RATE setting. The accumulated time of pumping and
			volume dispensed is reset to zero. Then press the START/STOP
			key .
		XXX mL/min	Pump(s) starts; press again pump(s) stops
	START
	STOP	or	To start pumping at this setting, press the START/STOP key.
		XXX L/min	The display enters the RUNNING Display Mode, and the fluid
			begins to dispense.
			LEDs indicate new pump direction
		Must STOP first!
INLET
SELECT			To select the other inlet and reverse the direction of pumping:
			1. Press the START/STOP key. The display returns to the
			STOPPED Display Mode.

2.Press the INLET SELECT key to reverse the direction of pumping.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Defining the Direction of Pumping, refer to Section 5.2.

	STOP to Prime...	Pumps fluid at current flow rate
PRIME		setting as long as the key is pressed

To prime a tube:

1.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode.

2.Press and hold down the PRIME key to prime the tube.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Priming a Tube”, refer to Section 5.4.

xxx °C Display alternates when pressed, °C then °F

TEMP

NOTE: The TEMP key functions the same whether the pump is stopped or running. Refer to Section 5.6.

xxx rpm Displays actual RPM

RPM

Press the RPM key. The display flashes the actual pump motor speed (xxx rpm).

6-9