|
|
| Table | RPM MODE |
| KEY | DISPLAY | ACTION TAKEN | |
|
|
| SHOWS | AND PROCEDURE |
|
|
|
|
|
|
|
|
| Pump motor’s power |
| ON/OFF Switch | xxx rpm |
| |
|
|
|
| NOTE: if you turn off the pump motor’s power, the pump stops |
|
|
|
| running. |
|
|
|
| To continue pumping, turn on the unit’s power. The display |
|
|
|
| returns to the STOPPED Display Mode and shows the current |
|
|
|
| RPM setting. The accumulated time of pumping and volume |
|
|
|
| dispensed is reset to zero. Then press the START/STOP key. |
|
|
|
|
|
|
|
| xxx rpm | Pump(s) stops; press again pump(s) starts |
|
| START | ||
|
|
|
| |
|
| STOP |
| To resume pumping at the current setting, press the |
|
|
|
| |
|
|
|
| START/STOP key. The display enters the RUNNING Display |
|
|
|
| Mode, and the fluid begins to dispense. |
|
|
|
|
|
|
|
| Must STOP first! | LEDs indicate new pump direction |
| INLET |
| ||
|
|
| ||
| SELECT |
|
|
|
|
|
|
| To select the other inlet and reverse the direction of pumping: |
|
|
|
| |
1.Press the START/STOP key. The display returns to the STOPPED Display Mode.
2.Press the INLET SELECT key to reverse the direction of pumping.
3.Press the START/STOP key again to resume pumping.
4.For detailed instructions on “Defining the Direction of Pumping, refer to Section 5.2.
STOP to Prime... | Pumps fluid at current RPM setting as long as the key is pressed |
PRIME
To prime a tube:
1.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode.
2.Press and hold down the PRIME key to prime the tube.
3.Press the START/STOP key again to resume pumping.
4.For detailed instructions on “Priming a Tube”, refer to Section 5.4.
TEMP
xxx °C
Display alternates when pressed, °C then °F
NOTE: The TEMP key functions the same whether the pump is stopped or running. Refer to Section 5.6.
|
| xxx rpm | Displays current RPM setting | |
RPM | ||||
| ||||
|
| |||
1. Press the RPM key. The display flashes the RPM setting you selected just before starting the pump.
2.Use the UP and DOWN ARROW keys to enter the RPM setting you desire. As you use the UP and DOWN ARROW keys, the display changes accordingly.
Displays cumulative TIME since start
TIME | xx:xx:xx |
Press the TIME key. The display flashes the time that the pump has been running (xx:xx:xx).