Omega Vehicle Security FPU5-MT-220 manual Troubleshooting Guide, Display Error Messages, Solution

7 Troubleshooting Guide

7.1 Display Error Messages

Error Message	Problem
CAL OVERFLOW!	While calibrating, you
	have allowed the motor
	to run at a high RPM
	setting for a very long
	time, or you have entered
	a total volume that would
	result in an inappropriate
	calibration factor.

Solution

1.Repeatedly press the CALIBRATE key until the message “Prime or START?” appears.

2.Repeat calibration but only allow the pump to run for a minute or two. NOTE: Make sure that you measure the volume of the dispensed fluid accurately.

Calibration FAIL	Your attempt to calibrate	1.	Repeatedly press the
	was unsuccessful.		CALIBRATE key until
			the message “Prime or
			START?” appears.
		2.	Repeat calibration but only
			allow the motor to run for a
			minute or two.
			NOTE: Make sure that you
			measure the volume of the
			dispensed fluid accurately.
Illegal Op Code	A	A
	The line voltage may	1.	Use a multimeter to measure
	be bad.		the line voltage used by the
			pump motor.
		2.	Compare the voltage rating
			on the unit’s label (on the back
			of the pump motor) with the
			line voltage to make sure that
			you are using the correct volt-
			age. The pump motor
			requires line voltages of 90 to

130 Vac (for 115 Vac units) or 190 to 260 Vac (for 220 Vac units).

7-1