Omega Vehicle Security FPU5-MT-110, FPU5-MT-220 manual Cont’d

	Table 6-1 (cont’d)				RPM MODE
KEY		DISPLAY			ACTION TAKEN
		SHOWS			AND PROCEDURE
		xxx mL/min			Displays actual FLOW RATE
FLOW
RATE		or
			Press the FLOW RATE key. The display flashes the fluid flow
		xxx Liter/min
			rate calculated for the RPM setting previously selected (xxx
			mL/min or xxx L/min).
		xxx mL			Displays current TOTAL VOLUME
	TOTAL
	VOLUME	or	1.	Press the TOTAL VOLUME key. The display flashes the
		xxx Liters		calculated volume of fluid dispensed since the pump started
				running (xxx mL or xxx Liters).
		TUBE ID=xxx			Displays current TUBE ID
TUBE ID
			Press the TUBE ID key. If the red LED next to the CALIBRATE
			key is not lit, the display flashes the current TUBE ID setting. If
			the red LED next to the CALIBRATE key is lit, the display flashes
			the message “CALIBRATED TUBE!”.
		CALIBRATED!			Displays calibration state
	CALIBRATE
		or
		not calibrated	1.	Press the CALIBRATE key. If the red LED next to the
				CALIBRATE key is not lit, the display shows “not calibrat-
				ed”.. If the red LED next to the CALIBRATE key is lit, the
				display shows “CALIBRATED!”.
			To calibrate a tube:

2.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode. For detailed instructions on “Calibrating a Tube”, refer to Section 5.5.

and 	xxx rpm	NOTE: if you press the UP and DOWN ARROW keys, the dis-
		play shows the current RPM setting. This setting
		changes accordingly as you use the UP and DOWN
		ARROW keys but does not wrap around at 10 RPM and
		600 RPM while the pump is running. Refer to Figure 6-2.
Language		NOTE: if you press the Language button, the display changes to
Button		the next language in the sequence: English, French,
		Spanish, German, and Italian.

6-4