Omega Vehicle Security FPU5-MT-110, FPU5-MT-220 manual Time Mode

				Table 6-3	TIME MODE
	KEY			DISPLAY	ACTION TAKEN
				SHOWS	AND PROCEDURE
ON/OFF Switch				xx:xx:xx	Pump motor’s power
				NOTE: if you turn off the pump motor’s power, the pump stops
					running.
				To continue pumping, turn on the unit’s power. The display
				returns to the STOPPED Display Mode and shows the time
				elapsed during pumping. Then press the START/STOP key.
				xx:xx:xx	Pump(s) stops; press again pump(s) starts
		START
		STOP		To resume pumping for the remainder of the TIME setting, press
				the START/STOP key. The display enters the RUNNING Display
				Mode, and the fluid begins to dispense.
				Must STOP first!	LEDs indicate new pump direction
	INLET
	SELECT
				To select the other inlet and reverse the direction of pumping:
			1.		Press the START/STOP key. The display returns to the
					STOPPED Display Mode.

2.Press the INLET SELECT key to reverse the direction of pumping.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Defining the Direction of Pumping, refer to Section 5.2.

	STOP to Prime...	Pumps fluid at current rpm or flow rate
PRIME		setting as long as the key is pressed

To prime a tube:

1.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode.

2.Press and hold down the PRIME key to prime the tube.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Priming a Tube”, refer to Section 5.4.

xxx °C Display alternates when pressed, °C then °F.

TEMP

NOTE: The TEMP key functions the same whether the pump is stopped or running. Refer to Section 5.6.

xxx rpm Displays actual RPM

RPM

Press the RPM key. The display flashes the actual pump motor speed (xxx rpm).

6-14