Rinnai EX11C (RHFE-265FTA), EX08C (RHFE-202FTA) installation manual Connecting the Appliance, shown

Connecting the Appliance

1. Attach the air inlet hose to the flue manifold on	a
either inlet position “a” or “b”.
The plastic tie should be tight over the sleeve.
The unused inlet is plugged with the rubber cap	b
supplied on the manifold.

2.Connect the flue elbow to the manifold while moving the appliance into position.

Flue Manifold

3.Fit the pipe stopper over the connection between the flue elbow and the manifold. Engage the hook and rotate it until it snaps against the body of the clamp.

Pipe stopper

		Hook
Elbow	Manifold
		Pipe stopper
4. Slide the insulation sleeve up to the flue manifold	Fit Clip
and slip the securing clip over the sleeve as
shown.			Slide

Sock

5.Install the bracket on the rear of the top spacer by tightening 2 screws.

6.Install the wall bracket with two screws. Install the top spacer by clipping the spacer into the wall brackets and attaching it to the heater with 2 screws.

Top Spacer	Spacer	Wall	2 screws
	Bracket		Top Spacer
		Bracket

Spacer

Bracket

Wall

Bracket

26 Rinnai Corporation EX08C, EX11C Manual